Change the remote access PIN code
Note
•• The default answering machine remote access PIN code is 0000 and it is important to change it to ensure the security.
1 | Tap |
| from the main menu screen. |
| |||
| |||
2 | Select [Remote access] > [Change PIN]. | ||
3 | Enter the old remote access PIN/passcode, | ||
4 | then tap [OK] to confirm. | ||
Enter the new remote access PIN/ | |||
5 | passcode, then tap [OK] to confirm. | ||
Enter the new remote access PIN/ | |||
passcode again, then tap [OK] to confirm. »»The setting is saved.
Charge the handset
Place the handset on the base station to charge the handset. When the handset is placed correctly on the base station, you hear a docking tone (see 'Set the docking tone' on page 40).
»»The handset starts charging.
Note
•• Charge the battery for 6 hours before first use.
•• It is normal for the handset to become warm during charging.
•• Over time, capacity of batteries decreases.This is a normal battery behavior.
•• You can order replacement batteries through www. philips.com or the Philips Service organization.
•• When the phone is not in use, place the handset to the base station or charging cradle.
Your phone is now ready to use.
8EN
Check the battery level
The battery icon displays the current battery level.
When the handset is off the base station/charger, the bars indicate the battery level (from full to low). When the handset is on the base station/charger, the bars keep scrolling until charging is complete.
When the battery is empty, this icon flashes. If you are in a call you hear an alert tone.
The battery is low and needs recharging.
If you are on the phone, you hear warning tones when the battery is almost empty. The handset turns off when the battery is completely empty.
What is standby mode?
Your phone is in standby mode when it is idle. In standby mode the screen will display the time and date and notifications of missed calls or messages. Depending on your settings, a screensaver will also be displayed in standby mode (see 'Screen saver' on page 42).The