Uniden EXS 2010 manual Installing the handset battery pack

Page 11

Installing the handset battery pack

Charge the battery pack for 15 - 20 hours before you start using your phone.

Black

Red

SPDIGITAL

SP REA

ECTRAM D

900

MHz

status LED

1 Press the battery cover release.

2 Connect the battery pack connector with the correct polarity (black and red wires), then insert the battery pack into the battery compartment.

3 Slide the battery cover forward until it snaps into place.

4 Place the handset on the base.

5 Make sure that the status

LED lights. If the LED doesn’t light, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts.

Use only Uniden Battery (BT-905) supplied with your phone.

9

Image 11

Contents Introduction FeaturesControls and functions Contents Handset Read this firstBase unit Checking the package contents Choose the best location Setting up the base unitConnect the base unit If you want to install the base unit on the wall, seeIf you arent sure of your dialing system Choose the dialing modeIf your dialing system is Set the switch to Tone PulseDC in 9V jack Direct wall plate mounting Installing the handset battery pack Automatic digital code security Battery use time per chargeWhen the battery charge becomes low Cleaning the charging contactsOther Operations Making a callHandset off the base Receiving a callRinger mute Handset on the baseFlash and Call Waiting Adjusting the ringer and earpiece volumeRedialing a call Mute When speaking on the handsetWhen the phone is ringing Standby Using page featureStoring phone numbers Chain dialing Making calls with memory dialing Memory dialingErasing a stored phone number To attach the beltclip To remove the beltclip Installing the beltclipHeadset installation When very dirty MaintenanceBattery replacement and handling When slightly dirtySymptom Suggestion TroubleshootingAt Uniden, we’ll take care of you V, W, X, Y, Z IndexJ, K, L