Uniden EXS 2010 manual Making a call, Other Operations

Page 13

If the talk/batt LED does not stop flashing after pressing the talk key, place the handset on the base for at least five seconds and make a call again.

BASICS

Making a call

1 Press talk . Listen for dial tone.

2 Dial the phone number.

3 To hang up, press talk or return the handset to the base.

Other Operations

To	Do this
To adjust the ear speaker volume	Press	• or	ª during the call.
To temporarily switch to tone dial	Press	tone	. The following
(When the base is set to pulse	numbers will be sent as tone
mode)	dialing.

To improve reception	Press	channel .

11

Image 13

Contents Introduction FeaturesControls and functions Contents Base unit Read this firstHandset Checking the package contents Choose the best location Setting up the base unitConnect the base unit If you want to install the base unit on the wall, seeIf your dialing system is Set the switch to Tone Choose the dialing modePulse If you arent sure of your dialing systemDC in 9V jack Direct wall plate mounting Installing the handset battery pack When the battery charge becomes low Battery use time per chargeCleaning the charging contacts Automatic digital code securityOther Operations Making a callRinger mute Receiving a callHandset on the base Handset off the baseFlash and Call Waiting Adjusting the ringer and earpiece volumeRedialing a call When the phone is ringing When speaking on the handsetMute Standby Using page featureStoring phone numbers Chain dialing Making calls with memory dialing Memory dialingErasing a stored phone number Headset installation Installing the beltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenanceWhen slightly dirty When very dirtySymptom Suggestion TroubleshootingAt Uniden, we’ll take care of you J, K, L IndexV, W, X, Y, Z