Uniden EXP900 important safety instructions Important Safety Instructions

Page 1

Important Safety Instructions

When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following:

1.Read and understand all instructions.

2.Follow all warnings and instructions marked on the product.

3.Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a dry cloth for cleaning.

4.Do not use this product near water; for example, near a sink or in a wet area.

5.Do not place this product on an unstable cart, stand, or table. The telephone may fall, causing serious damage to the unit.

6.To protect the product from overheating, do not block or cover any slots or openings in the Base Unit. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation unless proper ventilation is provided.

7.This product should be operated only from the type of power source indicated on the marking label.

8.Do not allow anything to rest on the power cord. Do not locate this product where the cord will be damaged by persons walking on it.

9.Do not overload wall outlets and extension cords, as this can result in the risk of fire or electrical shock.

10.Never push objects of any kind into this product through the Base Unit slots, as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.

11.To reduce the risk of electric shock, do not disassemble this product. Contact qualified service personnel when some service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the appliance is subsequently used.

1

Page 1 Page 2
Image 1
Page 1 Page 2
Contents Important Safety Instructions Page Introduction FeaturesAbout the EXP900 What’s Included with Your EXP900 Installing Your EXP900 InstallationSelecting the Installation Location Connecting the Telephone LineInstalling the Base Unit on a Desk or Tabletop Setting the TONE/PULSE SwitchPage Mounting the Base Unit on a Wall Setting the Handset RetainerMounting on a Standard Wall Plate Page Mounting Directly on a Wall Page Page Installing the Belt Clip Installing the Battery PackCleaning the Battery Contacts Low Battery IndicatorCharging the Handset Operating Instructions Using the Optional Headset HS900Placing a Call When the Handset Is on the BasePick up the handset and press When the Handset Is off the Base2ABC 3DEF Answering a Call When the EXP900 rings, pick up the handset and press any key Selecting a Channel Setting the Handset Receiver Volume Using the Flash ButtonStoring a Number in Memory Using the Redial ButtonTalk LED flashes and you hear a beep Enter a number 0-9 for the memory location you wish to use Storing a Mixed Tone/Pulse Number with a Pulse Dial System Enter the number to be dialed in Pulse Mode You hear a long beep and the Talk LED goes out Chain Dialing Dialing a Stored NumberErasing a Stored Number Using the Page Feature Turning the Ringer Off Setting the Ring TypeSetting the Ring Volume Range TroubleshootingRadio Interference Optional Accessories and Replacement Parts Battery SpecificationsGeneral Base UnitEXP900 Lead Acid Battery Precautions PrecautionsBefore you read anything else, please observe the following Base Controls and Indicators Front Handset ControlsKeypad Table Of Contents Product Registration Card Fold and seal with address to the outside One Year Limited Warranty Uniden America Corporation All Rights Reserved
Top Page Image Contents