Uniden EXP900 important safety instructions

Page 2

12.Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

A.When the power supply cord is damaged or frayed.

B.If liquid has been spilled into the product.

C.If the product has been exposed to rain or water.

D.If the product does not operate normally when following the operating instructions. Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation.

E.If the product has been dropped or the cabinet has been damaged.

F.If the product exhibits a distinct change in performance.

13.Do not use the telephone to report a gas leak in the vicinity of the leak.

CAUTION

To reduce the risk of fire or injury to persons by the battery, read and follow these instructions:

1.Use only the appropriate type and size Battery Pack specified in this Operating Guide.

2.Do not dispose of the Battery Pack in a fire. The cell may explode. Check the Lead Acid Battery Disposal information at the beginning of this Guide for disposal instructions.

3.Do not open or mutilate the Battery Pack. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

4.Exercise care in handling the battery in order not to short out the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns.

5.Charge the Battery Pack provided with or identified for use with this product only in accordance with the instructions and limitations specified in the instruction manual provided for this product.

6.Observe proper polarity orientation between the Battery Pack and battery charger.

SAVE THESE INSTRUCTIONS

2

Image 2
Contents Important Safety Instructions Page About the EXP900 FeaturesIntroduction What’s Included with Your EXP900 Selecting the Installation Location InstallationInstalling Your EXP900 Connecting the Telephone LineSetting the TONE/PULSE Switch Installing the Base Unit on a Desk or TabletopPage Setting the Handset Retainer Mounting the Base Unit on a WallMounting on a Standard Wall Plate Page Mounting Directly on a Wall Page Page Installing the Battery Pack Installing the Belt ClipCharging the Handset Low Battery IndicatorCleaning the Battery Contacts Using the Optional Headset HS900 Operating InstructionsWhen the Handset Is on the Base Placing a CallWhen the Handset Is off the Base Pick up the handset and press2ABC 3DEF Answering a Call When the EXP900 rings, pick up the handset and press any key Selecting a Channel Using the Flash Button Setting the Handset Receiver VolumeUsing the Redial Button Storing a Number in MemoryTalk LED flashes and you hear a beep Enter a number 0-9 for the memory location you wish to use Storing a Mixed Tone/Pulse Number with a Pulse Dial System Enter the number to be dialed in Pulse Mode You hear a long beep and the Talk LED goes out Dialing a Stored Number Chain DialingErasing a Stored Number Using the Page Feature Setting the Ring Type Turning the Ringer OffSetting the Ring Volume Troubleshooting RangeRadio Interference Optional Accessories and Replacement Parts General SpecificationsBattery Base UnitEXP900 Before you read anything else, please observe the following PrecautionsLead Acid Battery Precautions Base Controls and Indicators Keypad Handset ControlsFront Table Of Contents Product Registration Card Fold and seal with address to the outside One Year Limited Warranty Uniden America Corporation All Rights Reserved