Uniden Installing Your EXP900, Selecting the Installation Location

Page 5

Installation

Installing Your EXP900

Selecting the Installation Location

Select a location for the EXP900 to avoid excessive heat or humidity (as in a kitchen or bathroom). The Base Unit of your EXP900 can be placed on a desk or tabletop near a standard 120V AC outlet and telephone line jack, mounted on a standard AT&T or GTE wall plate, or mounted directly on the wall. Keep the Base Unit and Handset away from sources of electrical noise (motors, fluorescent lighting, etc.). Be sure there is sufficient space to safely extend the Base Unit antenna fully.

Connecting the Telephone Line

There are three types of phone outlets:

∙Modular.

∙4-prong jack.

∙Hard-wired type.

Modular Jack

Plug the telephone line cord from the Base Unit into a standard modular telephone jack.

Note: If you do not have a modular jack, contact your local telephone company for information on the installation of these jacks.

4-Prong Jack

An adapter (not included) is required. The adapter plugs into the 4-prong jack and the telephone line cord plugs into the adapter.

Hard-wired Jack

A modular jack converter (not included) is required. You may need to rewire when connecting the converter (making color-coded connections).

Note: Your Uniden Cordless Telephone Dealer or a telephone supply store can advise you on the proper adapter or converter.

CAUTION:

∙Never install telephone wiring during a lightning storm.

∙Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

∙Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

∙Use caution when installing or modifying telephone lines.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Important Safety Instructions Page About the EXP900 FeaturesIntroduction What’s Included with Your EXP900 Installing Your EXP900 InstallationSelecting the Installation Location Connecting the Telephone LineInstalling the Base Unit on a Desk or Tabletop Setting the TONE/PULSE SwitchPage Mounting the Base Unit on a Wall Setting the Handset RetainerMounting on a Standard Wall Plate Page Mounting Directly on a Wall Page Page Installing the Belt Clip Installing the Battery PackCharging the Handset Low Battery IndicatorCleaning the Battery Contacts Operating Instructions Using the Optional Headset HS900Placing a Call When the Handset Is on the BasePick up the handset and press When the Handset Is off the Base2ABC 3DEF Answering a Call When the EXP900 rings, pick up the handset and press any key Selecting a Channel Setting the Handset Receiver Volume Using the Flash ButtonStoring a Number in Memory Using the Redial ButtonTalk LED flashes and you hear a beep Enter a number 0-9 for the memory location you wish to use Storing a Mixed Tone/Pulse Number with a Pulse Dial System Enter the number to be dialed in Pulse Mode You hear a long beep and the Talk LED goes out Chain Dialing Dialing a Stored NumberErasing a Stored Number Using the Page Feature Turning the Ringer Off Setting the Ring TypeSetting the Ring Volume Range TroubleshootingRadio Interference Optional Accessories and Replacement Parts Battery SpecificationsGeneral Base UnitEXP900 Before you read anything else, please observe the following PrecautionsLead Acid Battery Precautions Base Controls and Indicators Keypad Handset ControlsFront Table Of Contents Product Registration Card Fold and seal with address to the outside One Year Limited Warranty Uniden America Corporation All Rights Reserved
Top Page Image Contents