Uniden EXP900 Charging the Handset, Low Battery Indicator, Cleaning the Battery Contacts

Page 15

Charging the Handset

Place the handset on the base to charge.

Low Battery Indicator

When the Battery Pack in the Handset is low and needs to be charged, the BATT LOW LED flashes every 3 seconds.

If this occurs while you are on the phone, you hear an alert tone. Complete your call as quickly as possible, and return the Handset to the Base Unit for charging.

TALK

TALK

1

4 GH I

7PRS

TONE

	BATT LOW
MEM	VOL CH
	R.VOL R.TONE
2ABC	3DEF
5 JKL	6MNO
8TUV	9 WXY
0OPER
FLASH	REDIAL

Allow 12 to 16 hours without any interruption for the Handset to fully recharge.

Cleaning the Battery Contacts

To maintain a good charge, it is important to clean all battery contacts on the Handset and Base Unit about once a month. Use a pencil eraser or other contact cleaner. Do not use any liquids or solvents.

900MHz

TALK

1

2ABC

3DEF

4 GH I

5 JKL

6MNO

7PRS

8TUV

9 WXY

0

FLASH

Contacts

15

Image 15

Contents Important Safety Instructions Page Features IntroductionAbout the EXP900 What’s Included with Your EXP900 Connecting the Telephone Line InstallationInstalling Your EXP900 Selecting the Installation LocationInstalling the Base Unit on a Desk or Tabletop Setting the TONE/PULSE SwitchPage Mounting the Base Unit on a Wall Setting the Handset RetainerMounting on a Standard Wall Plate Page Mounting Directly on a Wall Page Page Installing the Belt Clip Installing the Battery PackLow Battery Indicator Cleaning the Battery ContactsCharging the Handset Operating Instructions Using the Optional Headset HS900Placing a Call When the Handset Is on the BasePick up the handset and press When the Handset Is off the Base2ABC 3DEF Answering a Call When the EXP900 rings, pick up the handset and press any key Selecting a Channel Setting the Handset Receiver Volume Using the Flash ButtonStoring a Number in Memory Using the Redial ButtonTalk LED flashes and you hear a beep Enter a number 0-9 for the memory location you wish to use Storing a Mixed Tone/Pulse Number with a Pulse Dial System Enter the number to be dialed in Pulse Mode You hear a long beep and the Talk LED goes out Chain Dialing Dialing a Stored NumberErasing a Stored Number Using the Page Feature Turning the Ringer Off Setting the Ring TypeSetting the Ring Volume Range TroubleshootingRadio Interference Optional Accessories and Replacement Parts Base Unit SpecificationsBattery GeneralEXP900 Precautions Lead Acid Battery PrecautionsBefore you read anything else, please observe the following Base Controls and Indicators Handset Controls FrontKeypad Table Of Contents Product Registration Card Fold and seal with address to the outside One Year Limited Warranty Uniden America Corporation All Rights Reserved