Uniden EXP900 Precautions, Before you read anything else, please observe the following

Page 40

Precautions

Before you read anything else, please observe the following:

WARNING!

Uniden America Corporation DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOT expose this unit to rain or moisture.

Lead Acid Battery Precautions

Before you read anything else, please observe the following:

LEAD ACID BATTERY WARNING

This equipment contains a rechargeable sealed Lead Acid Battery.

The rechargeable sealed Lead Acid Battery contained in this equipment may explode if disposed of in a fire.

Do Not short-circuit the battery.

Do Not charge the rechargeable sealed Lead Acid Battery used in this equipment in any charger other than the one designed to charge this battery as specified in this guide. Using another charger may damage the battery or cause the battery to explode.

IMPORTANT NOTICE

Do Not allow the battery to drain fully. Once drained fully, the Lead Acid Battery cannot be recharged. If the battery becomes low, place the handset in the base and recharge it fully before using it again.

RECHARGEABLE LEAD ACID BATTERIES MUST BE

RECYCLED OR DISPOSED OF PROPERLY

Residents of Minnesota should call 1-800-225-PRBA for information concerning reclamation and disposal of rechargeable Lead Acid batteries.

Residents outside of Minnesota should contact their local authorities for information concerning reclamation and disposal of rechargeable Lead Acid batteries.

This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

Page 39 Page 41
Image 40
Page 39 Page 41
Contents Important Safety Instructions Page Introduction FeaturesAbout the EXP900 What’s Included with Your EXP900 Installation Installing Your EXP900Selecting the Installation Location Connecting the Telephone LineSetting the TONE/PULSE Switch Installing the Base Unit on a Desk or TabletopPage Setting the Handset Retainer Mounting the Base Unit on a WallMounting on a Standard Wall Plate Page Mounting Directly on a Wall Page Page Installing the Battery Pack Installing the Belt ClipCleaning the Battery Contacts Low Battery IndicatorCharging the Handset Using the Optional Headset HS900 Operating InstructionsWhen the Handset Is on the Base Placing a CallWhen the Handset Is off the Base Pick up the handset and press2ABC 3DEF Answering a Call When the EXP900 rings, pick up the handset and press any key Selecting a Channel Using the Flash Button Setting the Handset Receiver VolumeUsing the Redial Button Storing a Number in MemoryTalk LED flashes and you hear a beep Enter a number 0-9 for the memory location you wish to use Storing a Mixed Tone/Pulse Number with a Pulse Dial System Enter the number to be dialed in Pulse Mode You hear a long beep and the Talk LED goes out Dialing a Stored Number Chain DialingErasing a Stored Number Using the Page Feature Setting the Ring Type Turning the Ringer OffSetting the Ring Volume Troubleshooting RangeRadio Interference Optional Accessories and Replacement Parts Specifications BatteryGeneral Base UnitEXP900 Lead Acid Battery Precautions PrecautionsBefore you read anything else, please observe the following Base Controls and Indicators Front Handset ControlsKeypad Table Of Contents Product Registration Card Fold and seal with address to the outside One Year Limited Warranty Uniden America Corporation All Rights Reserved
Top Page Image Contents