Uniden EXP900 important safety instructions Mounting Directly on a Wall

Page 11

Mounting Directly on a Wall

If you do not have a standard wall plate, you can mount the EXP900 directly on a wall. Before mounting your cordless telephone, consider the following:

∙Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall.

∙Make sure the wall material is capable of supporting the weight of the Base Unit and Handset.

∙Use #10 screws with anchoring devices suitable for the wall material where the Base Unit will be placed.

1.Insert two number 10 screws, with the appropriate anchor device, in the wall 3 5/16 inches apart vertically, allowing about 1/5 of an inch between the wall and screw heads for mounting the phone. Make sure the screws are securely fastened, and that the wall material is capable of supporting the weight of the Base Unit; otherwise, damage to the Base Unit could result.

3 5/16"

2.Plug the AC Power Cord (1) and the Long Telephone Cord

(2) into the Base Unit.	1	2

11

Image 11

Contents Important Safety Instructions Page About the EXP900 FeaturesIntroduction What’s Included with Your EXP900 Connecting the Telephone Line InstallationInstalling Your EXP900 Selecting the Installation LocationInstalling the Base Unit on a Desk or Tabletop Setting the TONE/PULSE SwitchPage Mounting the Base Unit on a Wall Setting the Handset RetainerMounting on a Standard Wall Plate Page Mounting Directly on a Wall Page Page Installing the Belt Clip Installing the Battery PackCharging the Handset Low Battery IndicatorCleaning the Battery Contacts Operating Instructions Using the Optional Headset HS900Placing a Call When the Handset Is on the BasePick up the handset and press When the Handset Is off the Base2ABC 3DEF Answering a Call When the EXP900 rings, pick up the handset and press any key Selecting a Channel Setting the Handset Receiver Volume Using the Flash ButtonStoring a Number in Memory Using the Redial ButtonTalk LED flashes and you hear a beep Enter a number 0-9 for the memory location you wish to use Storing a Mixed Tone/Pulse Number with a Pulse Dial System Enter the number to be dialed in Pulse Mode You hear a long beep and the Talk LED goes out Chain Dialing Dialing a Stored NumberErasing a Stored Number Using the Page Feature Turning the Ringer Off Setting the Ring TypeSetting the Ring Volume Range TroubleshootingRadio Interference Optional Accessories and Replacement Parts Base Unit SpecificationsBattery GeneralEXP900 Before you read anything else, please observe the following PrecautionsLead Acid Battery Precautions Base Controls and Indicators Keypad Handset ControlsFront Table Of Contents Product Registration Card Fold and seal with address to the outside One Year Limited Warranty Uniden America Corporation All Rights Reserved