Hitachi HPW-200EC manual +FCLASS=n Select Service Class, +Fcommand? Report Active Configuration

4.FAX CLASS 1 COMMANDS

+FCLASS=n - Select Service Class

+FCLASS=n command sets the active service class.

Parameters:	0-1
Command options:
+FCLASS=0	Select Data Mode (default)
+FCLASS=1	Select Facsimile Class 1

+F<command>? - Report Active Configuration

+F<command>? interrogates the modem to determine the active configuration. Typical responses are:

+FCLASS?0 if in data mode; 1 if in fax mode (The modem supports class 1 only)

+F<command>=? - Report Operating Capabilities

+F<command>=? can be used to determine the operating capabilities of the modem.

Valid responses are:
+FCLASS=?		0 or 1
+FTM=?	24, 48, 72, 96, 73, 74, 97, 98, 121, 122, 145, 146
+FRM=?	24, 48, 72, 96, 73, 74, 97, 98, 121, 122, 145, 146
	Fax Modulation Table
Value		Modulation & Speed
3		V.21 ch. 2	300
24		V.27 ter	2400
48		V.27 ter	4800
72		V.29	7200
73		V.17	7200
74		V.17 w/st	7200
96		V.29	9600
97		V.17	9600
121		V.17	12000
122		V.17 w/st	12000
145		V.17	14400
146		V.17 w/st	14400

All other codes are reserved. st = V.17 short training

+FTS=n - Stop Transmission and Wait

+FTS=n causes the modem to terminate a transmission and wait for n 10-ms intervals before responding with the OK result code. An ERROR response code results if this command is issued while the modem is on-hook.

52