Casio IT-500 manual USB Port

1	USB Port	This port accepts connection of a USB cable for connection to a
		computer for transfer of system data and file data. Use of the
		USB port requires installation of a special driver on the PC.
2	RS-232C Port	This port accepts connection of an RS-232C cable for
	(IT-564IOE only)	connection to a computer for transfer of system data and file
		data. Use of the RS-232C port requires installation of a special
		driver on the PC.
3	RS-422C Port	This port is used when connecting to another Bridge Satellite
	(IT-564IOE only)	Cradle.
4	AC Adaptor Jack	Connect the AC adaptor here.
5	Wall Mount Unit	The holes in this plate accept screws that secure the wall mount
	Fastening Plate	unit in place.
6	Terminal Detect	This switch detects when the IT-500 is seated correctly on the
	Switch	Cradle.
7	Power Contacts	Power is supplied to the IT-500 via these contacts.
8	Power Indicator	This lamp indicates the power status and the mounting status of
	Lamp	the IT-500.
		Off: Power off
		Green: Power on, IT-500 mounted correctly
		Red: Power on, IT-500 not mounted
9	Communication	This lamp shows that the IT-500 is performing data
	Indicator Lamp	communication via a serial interface (RS-232C/RS-422).
	(IT-564IOE only)	Off: No data communication being performed
		Green flashing: Data communication in progress
		Red: Problem with a connection between two Cradles
10	System Status	This lamp indicates whether the system is operating normally.
	Indicator Lamp	Regardless of whether or not an IT-500 is mounted this lamp
		indicates the system status and whether or not a communication
		operation with the system can be performed.
		Off: System is not operating.
		Green: System is operating.
11	IR Port	This port transfers data with the IT-500 IR port non-contact data
		communication.
12	Power Switch	Turns the power on and off.
13	DIP Switches	Use these switches to configure the Cradle as required.
	(IT-564IOE only)

E-37