Casio IT-500 manual Connecting the AC Adaptor and Connecting to Computer

Connecting the AC Adaptor and Connecting to Computer

Use the AC adaptor available as option for the Bridge Satellite Cradle/Bridge Basic Cradle to supply the power to it. Always make sure that the power is being supplied to the Bridge Satellite Cradle/Bridge Basic Cradle by the AC adaptor before performing any type of data communication operation with the IT-500. The IT-500 draws the power via the Bridge Satellite Cradle/Bridge Basic Cradle during data communication.

1.After making sure that the Bridge Satellite Cradle/Bridge Basic Cradle power switch is turned off, plug the AC adaptor into the AC adaptor jack on the back.

When using the

RS-232C port

Power switch (OFF)

2. Next, plug the AC adaptor into a power outlet.

Power contacts

			Power switch (ON)
Power Indicator Lamp	POWER DATA	LINE	System Status Indicator Lamp

Communication Indicator Lamp (IT-564IOE only)

3.After making sure that the Bridge Satellite Cradle/Bridge Basic Cradle and your computer are both turned off, remove the cap from the RS-232C interface (IT-564IOE only) or USB interface on the back of the Bridge Satellite Cradle/Bridge Basic Cradle, and connect to your computer with an RS-232C cable (DT-887AXA) or USB cable (DT-380USB).

Be sure to keep the Bridge Satellite Cradle/Bridge Basic Cradle connection ports covered whenever you are not using them.

RS-232C Connection

•Connect an RS-232C cable (DT-887AXA) to the RS-232C port of the Bridge Satellite Cradle. Connect the other end to your computer’s RS-232C port.

USB Connection

•Connect a USB cable (DT-380USB) to the USB port of the Bridge Satellite Cradle/ Bridge Basic Cradle. Connect the other end to your computer’s USB port.

E-38