Acer manual Preparing to use your Acer n300, Rear view, Charging your Acer n300

Page 17

1 Getting started Preparing to use your Acer n300

Rear view

No.

Label

Description

 

 

 

1

Speaker

Outputs audio from your handheld.

 

 

 

2

Battery access

Unlatches the battery cover to remove the battery pack.

 

latch

 

 

 

 

3

Battery bay

Houses the handheld’s battery pack.

 

 

 

Preparing to use your Acer n300

Perform the following easy installation tasks to begin using your handheld:

Charge your handheld

Set up your handheld

Install the Microsoft® ActiveSync® software in your computer

Connect n300 to your computer

Perform the first ActiveSync operation

Charging your Acer n300

For initial use, you need to charge your handheld for four hours. After that, you can charge it for a few minutes each day to recharge the battery to full capacity. Normally,

7

Image 17
Contents User’s Guide Acer n300 HandheldCopyright Disposal instructions About this User’s Guide First things first Your guidesMaintaining your Acer n300 Package contentsPerforming a hard reset Resetting your Acer n300Performing a soft reset Maintaining your Acer n300 Contents Appendix a Regulation & safety notices System requirements Features summaryPerformance DisplayBattery Proprietary 26-pin I/O connectorAudio ConnectivityGetting started Acer n300 tour Acer n300 tourFront view Left view Using the backlightTop view Bottom view Rear view Preparing to use your Acer n300Charging your Acer n300 Getting started Preparing to use your Acer n300To charge your Acer n300 Preparing to use your Acer n300Power LED status during charging To set up your Acer n300 Setting up your Acer n300To install the Microsoft ActiveSync software Installing the Microsoft ActiveSync softwareConnecting the computer Via the USB Sync cable To connect the computerTo perform the first synchronization process Performing the first synchronization processBy clicking on its icon from Programs Getting started Command interface Command interfaceHandheld buttons and the stylus Start menuGetting started Command interface To launch Backup/Restore Backup and restore dataRestore function Backup functionTo perform data backup To perform data restorationTo delete a file from a storage device Tap Delete to remove the file Inserting an SD/MMC card Using an SD/MMC cardUsing expansion features Using an SD/MMC card Using expansion features Using an USB thumb drive Using an USB thumb driveRemoving an SD/MMC card Inserting an USB thumb drive Through the CradleFCC notice Appendix aDeclaration of Conformity for EU countries Operation conditionsRemarque à l’intention des utilisateurs canadiens Important safety instructions European Union EU LCD pixel statementRadio device regulatory notice General Exposure of humans to RF fields RSS-102 FCC RF safety requirementList of applicable countries Page Index