Pentair PS4, P4 Restarting the System Clear Memory Menu, PDA System Defaults and General Modes

4.2Restarting the System (Clear Memory) Menu

To remove all labeling, programming, assignments and temperature settings, highlight MENU and press SELECT. Highlight SYSTEM SETUP

and press SELECT (see Figure 30). Highlight CLEAR MEMORY and press SELECT. Highlight CONTINUE and press SELECT. Use the UP or DOWN button to highlight YES or NO and press SELECT. There will be about a 15 second delay before you see the FINISHED screen. Highlight CONTINUE and press SELECT to return to the

SYSTEM SETUP.

4.3PDA System Defaults and General Modes

Default Temperature (Pool/Spa Combination)

Default Pool Temp = 80° F

Default Spa Temp = 102° F

Default Temperature (Pool/Spa Only)

Default TEMP1 = 80° F

Default TEMP2 = 60° F

Default Spa Side Switch Settings

Button 1 = Spa (Filter Pump for pool/spa only models) Button 2 = Spa Heater (Temp1 pool/spa only models) Button 3 = AUX1

Button 4 = AUX2

Default Freeze Protection Settings

Filter Pump: Freeze Protection ON.

All Other Equipment: Freeze Protection OFF

Default Activation Temperature: 38° F

NOTE If you select SPA to be freeze protected, water circulation will switch between pool and spa every 30 minutes during freezing conditions once freeze mode is active.

4.3.1Power Center Service Switch

AUTO Mode (automatic)

1.The PDA Handheld Remote has complete control of all functions.

2.All programmed settings will operate.

3.All safety delays and equipment protection interlocks are operational.

SERVICE Mode

1.The power center has complete control of all functions.

2.Service mode must be turned on/off at the power center.

3.No programmed settings will work.

CAUTION

In service mode, equipment protection safety interlocks are overridden.