Follow these steps to mount the module on a wall.
1.Using the round holes in the mounting bracket as a tem- plate, mark the mounting screw locations on the wall.
2.Drill two holes in the wall at the marked locations.
3.While holding the bracket against the wall, thread a screw through each round hole in the bracket, then tighten the screws.
Hooks
Holes
Mounting Bracket
4.Route the cords through the openings in the bracket, then align the slots on the back of the module with the hooks on the bracket. Gen- tly push the module down on the bracket to secure it.
To remove the module from the bracket, press up from the bottom of the module until it snaps off the wall.
18