Panasonic KX-TCD410NL operating instructions Base Unit Selection

TCD410NL_E.book Page 33 Thursday, March 20, 2003 5:55 PM

Multi-unit User Operation

: Base Unit Selection

When Automatic Base Unit Access is selected, if you move outside of the radio range of the current base unit the handset automatically searches for other registered bases. When a specified base unit is selected, the handset will access that base unit only. Calls (both incoming and outgoing) can be conducted only via the selected base unit, even if the radio cells overlap with neighbouring base units.

1 2 3 4

Press MENU.	Search/Select	Search/Select	Search/Select
	"SETTING HS".	"SELECT BS".	"AUTO" or specific
			base unit number.

•To exit the operation, press any time.

Operating Additional Base Units: You can register and operate your handset with up to 4 base units. Each base unit forms 1 radio cell. If the individual bases are linked to the same telephone line then you can extend the operating range of the system by positioning the bases so that the two radio cells overlap. If the handset is set to AUTO base selection, then in standby mode the handset will automatically swap to the second base if the range on the first base is exceeded. It is not possible to transfer calls between bases (only between handsets linked to the same base unit).

					C
			1	2	3
			4
		C		5	6
1	2		7
		3		8	9
4	5						C
		6		0	1
7	8	9			4	2	3
	0				7	5	6
						8	9

	2					0
1						4
			C
	1	2	3
	4	5	6
	7	8	9
		0				C
				1	2	3
				4	5	6
		3		7	8	9
					0
Radio Cell					5

Eg. Additional handsets (KX-A142EX) registered with 2 base units.

Note:Calls are disconnected when the handset moves from one radio cell to another.

33

Cordless Telephone