Specifications

Problem	Cause/solution
Liquid or other form of	L Disconnect the AC adaptor and
moisture has entered the	telephone line cord from the base unit.
handset/base unit.	Remove the batteries from the handset
	and leave to dry for at least 3 days.
	After the handset/base unit are
	completely dry, reconnect the AC
	adaptor and telephone line cord. Insert
	the batteries and charge fully before
	use. If the unit does not work properly,
	contact your nearest Panasonic service
	centre.

Caution:

L To avoid permanent damage, do not use a microwave oven to speed up the drying process.

1{j/OK}

2{v}/{e}: “SETTING HS” i{>}

3{v}/{e}: “REGISTRATION” i{>}

4{v}/{e}: “REGISTER HS” i{>}

5Press and hold {x} on the base unit for about 5 seconds.

L If all registered handsets start ringing, press {x} to stop, then start again from step 1.

L The rest of the procedure must be completed within 4 minutes.

6{v}/{e}: Select a base unit number. i{>}

7Wait until “BS PIN” is displayed. iEnter the base unit PIN (default: “0000”). i{>}

LIf you forget your PIN, contact your nearest Panasonic service centre. L When the handset has been registered successfully, w stops

flashing.

L If w is still flashing, start again from step 1.

■Number of channels: 120 Duplex Channels

■Frequency range: 1.88 GHz to 1.90 GHz

■Duplex procedure:

TDMA (Time Division Multiple Access)

■Channel spacing: 1,728 kHz

■Bit rate: 1,152 kbit/s

■Modulation:

GFSK (Gaussian Frequency Shift Keying)

Approx. 10 mW (average power per channel)

■Voice coding: ADPCM 32 kbit/s

■Power source: 220–240 V AC, 50/60 Hz

■Power consumption: Base unit:

Standby: Approx. 1.2 W

Maximum: Approx. 3.9 W Charger*1:

Standby: Approx. 0.6 W

Maximum: Approx. 3.6 W

■Operating conditions:

5 °C–40 °C, 20 %–80 % relative air humidity (dry)