Panasonic KX-TG8070HK operating instructions Troubleshooting, Telephone Problem Cause & solution

Page 23

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit AC adaptor and remove the handset batteries. Then reconnect the base unit AC adaptor and install the batteries.

Telephone

Problem	Cause & solution
w is flashing and “Register!” is	L The handset is cancelled. If you want to register the
shown on the handset display.	handset to the base unit(s), follow “Registering a handset
	to a base unit”, page 19. If you want to use a base unit(s)
	which was registered to the handset before cancellation,
	select it by following “Selecting a base unit”, page 19.
w is flashing and “Searching...” is	L The handset is too far from the base unit. Move closer.
shown on the handset display.	L The base unit AC adaptor is not connected. Check the
	connections.
	L You may have selected the wrong base unit. Select the
	right base unit (page 19).
	L You are using the handset or base unit in an area with high
	electrical interference. Place the handset and base unit
	away from interference sources, such as antennas and
	mobile phones.
The handset display is blank.	L The handset is in screen saver mode (page 10). If
	charging, lift the handset to activate the handset display
	again. If the handset is not on the base unit, activate the
	handset display again by:
	– pressing {^} or {V} when on a call
	– pressing {i} for all other times
	L “Dimmed Backlight” is set to “Off”. Change the
	setting (page 15).
The handset will not turn on.	L Make sure that the batteries are installed correctly (page
	9).
	L Fully charge the batteries (page 9).
	L Clean the charge contacts and charge again (page 9).
I have changed the display language to	L Change the display language (page 10).
a language I cannot read.

23

Image 23

Contents Model No. KX-TG8070HK Table of Contents Introduction Additional/replacement accessories Accessory informationSupplied accessories Accessory items QuantityEnvironment Battery cautionImportant information GeneralControls Displays Location of base unit ConnectionsBattery charge Battery installation and replacementWhile charging Screen saver modeSetting up the unit before use If the handset is not on the base unitDate and time Dialling mode tone/pulseMaking calls Useful features during a callMaking a call using the redial list Pause for PBX/long distance service usersAnswering calls Handset phonebook Handset settings Handset names Special instructions for display setupDisplay Setup iOK Handset Name iOK Recall/Flash Base unit settingsRingtone Call Options Dial Mode PBX Access NoCaller list Using Caller ID serviceRegistering a handset to a base unit Operating additional unitsHandset Intercom between handsetsTransferring calls between handsets, conference calls Attaching the belt clip Removing the belt clip Using the belt clipNo Base Found Error messagesCharacter entry BusyTelephone Problem Cause & solution TroubleshootingProblem Cause & solution For DSL users Specifications Index Copyright HK-2/2PQQX15902ZA CC1007DA0 Hotline Tel. No Sole Agent for Hong Kong & Macau