Panasonic KX-TS840MX Connections, Initial setting, Dialing mode, Mprogramn, MHOLD/MODEN → M3N

Page 7

Preparation

Connections

Connect the handset cord (A) to the handset and the unit. Connect the telephone line cord until it clicks into the unit and telephone line jack (B). After line connection, lift the handset to check for a dial tone.

1

2

To single-line telephone jack

DSL/ADSL filter*

R Use only a Panasonic handset for KX-TS840MX.

R Use only the supplied telephone line cord. Using another telephone line cord may not allow the unit to work properly.

*DSL/ADSL filter (not supplied) is required if you have DSL/ADSL service.

Initial setting

Dialing mode

If you cannot make calls, change this setting according to your telephone line service.

The default setting is TONE. TONE: For tone dial service. PULSE: For rotary/pulse dial service.

1Lift the handset.

2MPROGRAMN

R Status indicator light will start double flashing at an interval.

3MHOLD/MODEN → M3N

4To select TONE, press M1N. or

To select PULSE, press M2N.

5MPROGRAMN

R A long beep sounds.

R Status indicator light will turn OFF.

6When finished, hang up.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Operating Instructions Making/Answering Calls IntroductionImportant Information PreparationSupplied accessories Accessory informationAttach your purchase receipt here For your safety Specifications Dial LOCK/EXITN page 10, 12 ControlsMprogramn Initial settingDialing mode ConnectionsMredialn Making callsAnswering calls MSP-PHONENFlash Useful features during a callHold MuteTemporary tone dialing for rotary/pulse service users For call waiting service usersDial lock Making/Answering Calls Memergencyn One-touch dialerUpper memory locations Lower memory locationsIndex card MAUTO/LOWERN → Press the one-touch dial buttonSpeed dialer MHOLD/MODEN → M5N Changing the unit passwordCall restriction MHOLD/MODEN → M1NTo adjust the headset receiver volume 4 levels Connecting the optional headset to the unitOptional headset Low desk position default High desk position Desk mount setupChanging to the high position Wall mount setup Wall Template General use Problem Cause/solution TroubleshootingMprogramn or M Dial LOCK/EXITN may have Liquid damage Problem Cause/solution Index Page Hotline Tel. No Sole Agent for Hong Kong & Macau
Top Page Image Contents