Uniden frs 300 manual Choosing a Channel, Scan Mode

Page 10

Choosing a Channel

Your radio has 14 preprogrammed channels that you can use to talk to others. You must select the same channel as your party selected.

To choose a channel for the FRS300:

Press the or button repeatedly to select one of the 14 channels.

(The number on the LCD changes to indicate that a new channel has been selected.)

The BUSY icon and icon appear while receiving a transmission.

Scan Mode

Your radio also allows you to scan for activity from other transmitting radios.

To use the Scan feature:

1. Press the scan button to begin scanning channels. The LCD will indicate that you are in scan mode.

If a signal is present, the radio will stop on the active channel. It will remain on the channel until the transmission ends. After 2 seconds, it will resume scanning.

7

Image 10
Contents Page Controls Call buttonFCC Information This device complies with Part 15 of the FCC RulesContents Welcome Included in Your Package Belt clip and screws FRS UnitBattery Installation Low Battery Alert Belt ClipAdjusting the Volume Using Your RadioTurning the Radio On Scan Mode Choosing a ChannelMonitor Mode Talking on Your RadioLocking In Your Selection Call Tone TransmissionLCD Backlight Silent KeypadExternal Microphone and Speaker Optional Troubleshooting Problem SolutionChannels Operating Frequency SpecificationsChannel Frequency Reserved Prcz@naic.edu.A-1§95.193 FRS Rule 3 Types of communications Transmitted continuously only while you are talkingMemo 409,688 455,679 461,036 521,915 597,104