Uniden frs 300 manual Monitor Mode, Talking on Your Radio

Page 11

2.To resume scanning prior to the transmission end, press scan again.

3.Press the scan, call, PTT, , or button to exit the scan mode, stopping at the current channel.

If you press scan to exit the scan mode, the radio must be actively scanning.

Monitor Mode

The Monitor Mode is used to check activity on a specific channel. It will allow you to receive signals that are considered too weak.

To check the channel activity:

1.Press and hold the MON button until you hear a series of beeps. You will hear background noise if the channel is clear. Don’t transmit if you hear conversation.

2.To turn the Monitor Mode off, press the MON button again.

Talking on Your Radio

To talk to others using the radio;

1.Determine your communicating channel with the other members of your party (refer to “Choosing a Channel” on page 7).

2.Press and hold the PTT button and speak into the microphone. The

following LCD screen appears.

3.When you finish speaking, release the PTT button. You cannot hear any signals while your PTT button is pressed.

4.Repeat steps 2 and 3 to continue communication.

8

Image 11
Contents Page Call button ControlsThis device complies with Part 15 of the FCC Rules FCC InformationContents Welcome Belt clip and screws FRS Unit Included in Your PackageBattery Installation Belt Clip Low Battery AlertTurning the Radio On Using Your RadioAdjusting the Volume Choosing a Channel Scan ModeTalking on Your Radio Monitor ModeCall Tone Transmission Locking In Your SelectionExternal Microphone and Speaker Optional Silent KeypadLCD Backlight Problem Solution TroubleshootingChannel Frequency SpecificationsChannels Operating Frequency Prcz@naic.edu.A-1 ReservedTransmitted continuously only while you are talking §95.193 FRS Rule 3 Types of communicationsMemo 409,688 455,679 461,036 521,915 597,104