Uniden frs 300 manual Low Battery Alert, Belt Clip

Page 8

Low Battery Alert

The LCD on your radio shows a battery meter in the lower right corner. The icon indicates a fully powered unit. As the

batteries become low, will flash. After 10 seconds, the channel number disappears.

When the batteries in the unit are low, the unit will go into a Battery Low/Sleep Mode. The Scan Mode, Transmit, and Transmit Call Tone Mode are disabled. Replace the batteries immediately to continue using the radio.

Belt Clip

Because you will most likely use your radio when you are out and about, the unit comes equipped with a belt clip to fasten the unit to your belt, pocket, or purse.

To remove the belt clip, turn the screws counterclockwise.

To attach the belt clip:

1. Insert the belt clip screws into the slot on the belt clip.

2. Align the screws with the holes on the back of the radio and turn them clockwise, using a Phillips screwdriver to secure the belt clip. Do not over-tighten.

5

Image 8
Contents Page Controls Call buttonFCC Information This device complies with Part 15 of the FCC RulesContents Welcome Included in Your Package Belt clip and screws FRS UnitBattery Installation Low Battery Alert Belt ClipTurning the Radio On Using Your RadioAdjusting the Volume Scan Mode Choosing a ChannelMonitor Mode Talking on Your RadioLocking In Your Selection Call Tone TransmissionExternal Microphone and Speaker Optional Silent KeypadLCD Backlight Troubleshooting Problem SolutionChannel Frequency SpecificationsChannels Operating Frequency Reserved Prcz@naic.edu.A-1§95.193 FRS Rule 3 Types of communications Transmitted continuously only while you are talkingMemo 409,688 455,679 461,036 521,915 597,104