Uniden FRS500 manual Press the ctcss/vibrate button. The code indicator flashes

Page 11

1. Press the ctcss/vibrate button. The code indicator flashes.

2.Press the up or down button repeatedly to select one of the CTCSS codes (0-38).

3.After selecting the desired CTCSS code, press the ctcss/vibrate button again. The code indicator stops flashing.

You must press the ctcss/vibrate button within 5 seconds or the unit will time out. If not, the setting will not be made.

4. To turn off the CTCSS code, press the up or down button until the code is selected. Then press the ctcss/ vibrate button again. The code indicator stops flashing.

If the code is selected on your radio, you can receive any signal on that channel regardless of the CTCSS code settings of the people in your party.

Image 11

Contents Page Controls On/off volumeFCC Information Contents Welcome Included in Your Package Battery Installation Belt Clip Low Battery AlertTurning the Radio On Using Your RadioAdjusting the Volume Busy icon and icon appear while receiving a transmission Choosing a Channel and CtcssPress the ctcss/vibrate button. The code indicator flashes Scan Mode Talking on Your Radio Monitor ModeLocking In Your Selection Vibration AlertExternal Microphone and Speaker Optional Call Tone TransmissionSilent Keypad LCD BacklightProblem Solution TroubleshootingChannel Frequency Chart MHz SpecificationsAppendix FRS Radio Rules FCC Part 95 Subpart B §95.194 FRS Rule 4 FRS units 409,688 455,679 461,036 521,915 597,104