Cobra Electronics PR260 WXC owner manual Caring for Your microTALK Radio

Page 6

 

 

 

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

 

Caring for Your microTALK® Radio

•

Your microTALK® radio will give you years of trouble-free service if cared for properly. Handle the radio gently. Keep the radio away from dust. Never put the radio in water or in a damp place. Avoid exposure to extreme temperatures.

Remove Belt Clip

Rechargeable Batteries and Charger

To install or replace batteries:

•

Pull Up Lock Latch

Insert Batteries

1.Release belt clip and pull up.

2.Press the battery door latch to

remove the battery compartment cover.

3.Insert the supplied four (4) AAA rechargeable batteries or non-rechargeable alkaline batteries. Position batteries according to polarity markings.

4.Replace battery compartment cover and belt clip.

Radio Charger Jack To charge batteries in radio:

1. Check to see that the batteries have been inserted properly.

2. Insert the wall charger/adapter into the charge jack located at the top of the radio. The wall charger/adapter has two round connectors which enables you to charge either one or two radios at a time.

3.Plug the wall charger/adapter into electrical outlet.

It normally takes 15 hours to fully recharge batteries. It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 8 hours.

Use only the supplied rechargeable batteries and wall charger/adapter for recharging your Cobra microTALK® radio.

1

Page 5 Page 7
Image 6
Page 5 Page 7
Contents PR260 WXC Automated Help Desk Making Life Easier and SaferFor Assistance in Canada or the U.S.A Customer Assistance OperatorsProduct Features Features Belt ClipWarranty Limited One-Year Warranty on Radios & ChargerRadio Charger Jack To charge batteries in radio Replace battery compartment cover and belt clipCaring for Your microTALK Radio Check to see that the batteries have been inserted properlyTo connect a wall charger/adapter Using Your RadioSpeaker/Microphone/Charge Jack To attach a speaker/microphoneAuto Battery Save Communicating with Another PersonListening for a Response To Adjust Volume Press the Volume Up or VolumeTo Select a Channel Call ButtonTo turn maximum range extender off Light/Max Range To temporarily turn off auto squelchTo turn maximum range extender on Lock FunctionYour range will vary depending on terrain and conditions Scrolling Through the Mode FunctionMicroTALK Range Set Privacy CodeCtcss Privacy Codes To select a privacy codeNOAA* All Hazards Radio Channels Mode FunctionsTo turn VOX mode on or off To listen to all hazards radio channelsTo Set VOX Sensitivity Channel ScanTo scan channels This will return the radio to Standby mode Privacy Code Scan To scan privacy codesPress the Mode/Power button to proceed to other functions If you press the Talk button while scanning and not withinOn or off setting is displayed Five Call Tone SettingsTo change a call tone setting Roger Beep Confirmation ToneGeneral Specifications and Licensing General SpecificationsLicensing Safety and Trademark Acknowledgement Safety Information for microTALK RadiosNormal Position Product Service
Top Page Image Contents