Setting the Dial Mode
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing; the default setting is tone dialing. Set the dialing mode to match the dialing system used by your local phone service.
•If you are not sure of your dialing system, make a trial call. If the call connects, leave the setting as is; otherwise set the unit to pulse dialing.
•If your phone system requires pulse dialing and you need to send DTMF tones in certain situations during a call, you may switch over to tone dialing (refer to "Tone Dialing
G E T T I N G S T A R T E D
1)Press menu/clear (or the MENU soft key on the base). Select the Global Setup menu, and then the Dial Mode submenu.
2)Press /volume up/down to select Tone or Pulse (the initial setting is Tone).
&KCN/QFG 6QPG
2WNUG
3)Press select/ /audio tone (or the OK soft key on the base). You will hear a confirmation tone.
w w w . u n i d e n . c o m | G E T T I N G S T A R T E D [ 2 8 ] |