Uniden DCT7488 Turning the Answering System On/Off, Setting Your Outgoing Message Greeting

Turning the Answering System On/Off

1) To turn the answering system on, press answer on/ off on the base when the phone is in standby mode or from the Answer Setup menu (see page 61).

/'55#)' and the number of messages stored in memory appear on the LCD. If the LCD flashes, then there are new messages waiting for you.

2)To turn the answering system off, press answer on/off on the base. #059'41(( appears on the LCD.

Setting Your Outgoing Message (Greeting)

When you receive a call, the answering system automatically plays either the pre- recorded message or your own greeting. To record your own greeting, or choose between the two outgoing messages, refer to “Answering System Setup” on page 57. The following message is pre-recorded: "Hello, no one is available to take your call. Please leave a message after the tone."

Announce only feature

The announce only feature plays a pre-recorded outgoing message or your own personal outgoing message, but it will not allow the caller to leave a message. To set announce only, follow the steps on "Setting the Record Time" on page 59. If you want to use your own greeting and you want to change your greeting to omit the prompt to leave a message, refer to “Selecting Your Greeting (Base only)” on page 57.

The following message is pre-recorded:

"Hello, no one is available to take your call. Please call again."

note

When the answering system is full, you will hear “No Remaining

Time“ and (7.. appears on the LCD. You should delete some messages so that the system can record new messages.

T H E I N T E G R A T E D A N S W E R I N G D E V I C E

w w w . u n i d e n . c o m T H E I N T E G R A T E D A N S W E R I N G D E V I C E [ 6 2 ]