Uniden DCT5280 manual O r e / E d i t N a m e M o v i e s, O r e / E d i t N o 0 7 3 0 3 4 5

3)Press the STORE soft key, “Store/Edit Name” appears.

4)Enter the name (up to 16 characters) by using the number keypad (see the “Steps for Entering Names and Special characters” on page 40).

If a name is not required, go to step 5. <No Name> will be used as the name.

S t o r e / E d i t N a m e M o v i e s

BACK DELETE OK

• When the memory is

full, you will hear a

beep and “Memory

Full” appears. You

cannot store names

5)Press the OK soft key to store the name, “Store/Edit No.” appears.

6)Press the number keypad to enter the phone number (up to 20 digits), press the OK soft key to store the number.

7)“Distinctive Ring” appears. Press volume/ ▲ or ▼ to move the pointer to one of the Distinctive Ring options, then press the OK soft key.

If you choose not to store a “Distinctive Ring”, simply select the “No Selectn” option.

S t o r e / E d i t N o .

8 0 0 7 3 0 3 4 5 6

DELETE PAUSE OK

D i s t i n c t i v e R i n g N o S e l e c t n

F l i c k e r

BACKOK

and numbers.

• The pause key counts

as one digit. Pressing

the PAUSE soft key

more than once

increases the length

of the pause between

numbers. Each pause

replesents a 2

second delay.

• Selecting a speed

dial location where a

number is already

stored, releases the

8)“Speed Dial” appears. Press volume/ ▲ or ▼ to move the pointer to select the Speed dial location (10 locations: SPD1-SPD0).

If you choose not to store the name/number as a Speed Dial, simply select the “No Selectn” option.

9)Press the OK soft key. You will hear a confirmation tone and “Done!” appears in the display.

S p e e d D i a l

N o S e l e c t n

S P D 1 : < E m p t y >

BACKOK

M o v i e s

8 0 0 - 7 3 0 - 3 4 5 6

F l i c k e r		/ S P D 2
BACK	DELETE	EDIT

old number’s speed

dial setting. The new

number will be

stored in the speed

dial location.

PHONEBOOK

P H O N E B O O K [ 39 ]