Uniden EXAI 5180 manual Installation Considerations

Page 62

Telephone Line Problems

The FCC has granted the telephone company the right to disconnect service in the event that your phone causes problems on the telephone line. Also, the telephone company may make changes in facilities and services which may affect the operation of your unit. However, your telephone company must give adequate notice in writing prior to such actions to allow you time for making necessary arrangements to continue uninterrupted service.

If you are having trouble with your telephone service, you must first disconnect your phone to determine if it is the cause of your problem. If you determine that it is the cause, you must leave it disconnected until the trouble has been corrected.

Radio Interference

Radio interference may occasionally cause buzzing and humming in your cordless handset, or clicking noises in the base. This interference is caused by external sources such as TV, refrigerator, vacuum cleaner, fluorescent lighting, or electrical storm. Your unit is NOT DEFECTIVE.

If these noises continue and are too distracting, please check around your home to see what appliances may be causing the problem.

In addition, we recommend that the base not be plugged into a circuit that also powers a major appliance because of the potential for interference. Be certain that antenna on the unit is fully extended.

In the unlikely event that you consistently hear other voices or distracting transmissions on your phone, you may be receiving radio signals from another cordless telephone or other source of interference. If you cannot eliminate this type of interference, you need to change to a different channel.

Finally, it should be noted that some cordless telephones operate at frequencies that may cause interference to nearby TVs and VCRs.

To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR.

If interference is experienced, moving the cordless telephone farther away from the TV or VCR will often reduce or eliminate the interference.

More Than One Cordless Telephone

If you want to use more than one cordless telephone in your home, they must operate on different channels. Press the channel key to select a channel that provides the clearest communication.

Cordless Telephone Privacy

Cordless telephones are radio devices. Communications between the handset and base of your cordless telephone are accomplished by means of radio waves which are broadcast over the open airways. Because of the inherent physical properties of radio waves, your communications can be received by radio receiving devices other than your own cordless telephone unit. Consequently, any communications using your cordless telephone may not be private.

Installation Considerations

Selecting a Location

Before choosing a location for your new phone, there are some

important guidelines you should consider:

The location should be close to both a phone jack and continuous power outlet. (A continuous power outlet is an AC outlet which does not have a switch to interrupt its power.)

Keep the base and handset away from sources of electrical noise such as motors or fluorescent lighting.

Be sure there is sufficient space to fully extend the base antenna.

The base can be placed on a desk or tabletop or mounted on a standard telephone wall plate.

You should charge your new phone for 15-20 hours before completing the installation or using the handset.

Telephone Line Outlets

There are two types of phone outlets:

Modular Jack

Most phone equipment available now uses modular jacks. Phone cords are fitted with a molded plastic connector which plugs into this type of jack. If you do not have modular phone jacks, contact your local telephone company for information about their installation.

Hardwired Jack

Some equipment is wired directly to a phone jack, and these types of installations require a modular jack converter. This type of installation is not difficult; however, you should contact your Uniden telephone dealer or a telephone supply store for advice about the proper adapter or converter for your particular situation.

Connecting the Telephone Cords

Consider these safety guidelines before connecting the telephone cords:

Caution!

Never install telephone wiring during a lightning storm.

Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected.

Use caution when installing or modifying telephone lines.

Applying Power to the Base

This phone requires an AC outlet, without a switch to interrupt power, and the included AC adapter. To relieve strain on the DC plug when the phone is placed on a desk or table, wrap the power cord around the strain relief notch on the back of the base.

NOTE:

Place the power cord so that it does not create a trip

 

hazard, or where it could become chafed and create a

 

fire or other electrical hazards.

One Year Limited Warranty

Important: Evidence of original purchase is required for warranty service.

WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”)

ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below.

WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effect 12 months after the date of original retail sale. The warranty is invalid if the Product is (A) damaged or not maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits, subassemblies, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner’s manual for this product.

STATEMENT OF REMEDY: In the event that the product does not conform to this warranty at any time while this warranty is in effect, warrantor will either, at its option, repair or replace the defective unit and return it to you without charge for parts, service, or any other cost (except shipping and handling) incurred by warrantor or its representatives in connection with the performance of this warranty. Warrantor, at its option, may replace the unit with a new or refurbished unit. THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you.

LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America and Canada.

PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner’s manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). The Product should include all parts and accessories originally packaged with the Product. Include evidence of original purchase and a note describing the defect that has caused you to return it. The Product should be shipped freight prepaid, by traceable means, to warrantor at:

Uniden America Corporation

Parts and Service Division

4700 Amon Carter Blvd. Fort Worth, TX 76155 (800) 297-1023, 8 a.m. to 5 p.m. Central, Monday through Friday

[ 62 ] A D D I T I O N A L I N F O R M AT I O N

www.uniden.com

Image 62
Contents Page Page Quick Contents Features WelcomeControls and Functions Repeat/rewind key Do the following steps Setting up the PhoneChoose the best location Install the rechargeable battery pack into the handset Getting StartedE T T I N G S TA R T E D Low battery alert Connect the base unit Mounting the Base Unit on a Wall Standard wall plate mountingDirect wall mounting Setting Menu Options Caller ID optionsChoosing the dialing mode Setting the language Making and Receiving Calls Handset On Base Handset Off BaseEarpiece volume Adjusting the Handset Ringer and Earpiece VolumeHandset ringer tone and volume Temporarily Mute RingerTraveling Out-of-Range Tone Dialing Switch OverRedial Selecting a Different Channel Storing Phone Numbers and Names Press memory or selectPress memory or select. Store Number is displayed Steps for Entering Names and Special Characters If you make a mistake while entering a nameMemory dialing from Standby Mode Making Calls with Memory DialingMemory dialing from Talk Mode Chain DialingEditing a Stored Name and/or Phone Number Replace Memory? Yes Memory01 Stored Movies Erasing a Stored Name and Phone Number Press select or delete/channelMaking Calls with the RocketDial RocketDialStoring and Editing the RocketDial Deleting the RocketDial RocketdialWhen the Telephone Rings Caller ID and Cidcw Caller ID on Call WaitingViewing the Caller ID Message List Press call id/menuDeleting Information from the Caller ID List When the pointer is at YesWhen the pointer is at No Deleting a Caller ID messageTone sounds and all stored Caller ID messages are deleted Calling a party from the Caller ID list Using the Caller ID ListLong Distance calls and Area Code Setting/Cancellation Storing Caller ID messages in Memory dialing Features Integrated Answering DeviceTurning the Answering System On/Off Setting Up Your Answering System Answering System SettingSetting the Time Setting a Personal Security Code PIN Setting the Ring Time Announce only feature Selecting the Message Record TimeSetting the Message Alert tone Selecting the Language Setting Your Outgoing Message GreetingPreset message Setting the Base Ringer Volume Choosing between the two outgoing messagesTemporarily Mute the Base Ringer Using Your Answering SystemAdjusting the Speaker Volume Level Playing your messages Repeating a messageSkipping a message Deleting a Message Voice memo Recording a conversationRemote access away from home Command FunctionTurn on the answering system remotely Changing the Digital Security Code Installing the BeltclipHeadset Installation To attach the beltclipPower Failure MaintenanceBattery replacement and handling Troubleshooting Symptom Suggestion Charge/in use LED wontSymptom Suggestion Liquid Damage Case ActionAC Adapter Information Battery InformationGeneral Information FrequencyImportant Electrical Considerations Installation Considerations Terminal Equipment Radio Equipment Index G, H, I, J, K, LRemote Operation Card Remote Operation CardTask Key At Uniden, we´ll take care of you