Uniden EXI 8965 owner manual Connect the base unit

Page 9

Step 2 (continued)

Connect the base unit

To install the base unit on the wall, see page 43.

 

(Used only when second line

Route the cord.

requires a separate jack.)

2

To AC outlet

To DC IN 9V

1

AC adapter (supplied)

To telephone outlet

Telephone line cord (supplied)

To TEL LINE

1 Connect the telephone line cord to the TEL LINE jack and to a telephone outlet.

3 2 Connect the AC adapter to the DC IN 9V jack and to a standard 120VAC wall outlet.

3 Set the base unit on a desk or tabletop and place the handset on the base unit.

Then raise the antenna to a vertical position.

Note

Place the power cord so it does not create a trip hazard, or where it could become chafed and create a fire or electrical hazard.

6

Image 9
Contents EXI Introduction FeaturesTalk Flash Controls and functions43 44 45 Table of contents 5 to Read this first8 to9 About the digital security codeStep Checking the package contentsChoose the best location Setting up the base unitConnect the base unit Tips Choose the dialing modePreparing the battery pack Battery use time per charge When the battery charge becomes lowCleaning the battery contacts Beep sounds and the displayed area code is entered Entering your area codeMaking calls Making a call with the handsetOn-hook dialing Off-hook dialing Making a call with the base On-hook redialing Redialing a call with the handsetOff-hook redialing Redialing a call with the baseAny key Talk when ringing Auto Talk when ringingMute when ringing Receiving callsHandset ringer switch Handset ear speaker volumeHandset ringer tone Base ringer switch Base speaker volumeReceiving a call with the base Memory storing Storing phone numbers and namesWith the handset Use With the base With the handset On-hook dialing Memory dialingDisplay a Programmed Number Standard dialing With the base One touch dialingEditing a stored name and/or phone number Memory editingMemory01 Stored Erasing a stored name and phone number Memory erasingWith the base When speaking with the handset When speaking with the baseWhen phone is ringing MuteWhen speaking on the handset Way conference featuresWhen speaking on the base Way conferenceUsing your EXI 8965 intercom Intercom featurePaging from the base to handset Paging from the handset to baseTransferring a call Call transfer featureTo transfer from the handset to the base To transfer from the base to the handsetUsing the speakerphone Speakerphone featureCaller ID service Setting the Caller ID optionsCaller ID Here are some typical displays When the telephone ringsViewing the Caller ID Message list Long Distance call settings and cancellationDeleting a Caller ID message Deleting information from the Caller ID listDeleting all Caller ID name/numbers Calling a party from the Caller ID list Using the Caller ID listLong Distance calls Dial editStoring Caller ID messages in Memory dialing Using Caller ID with call waiting service Changing the digital security code Additional informationStandard wall plate mounting Mounting the base unit on a wallDirect wall plate mounting Installing the beltclip Headset installationTo attach the beltclip To remove the beltclip Maintenance Battery replacement and handlingPower Failure Symptom Suggestion TroubleshootingGeneral SpecificationsBase unit HandsetIndex K, LW, X, Y, Z Page Uniden America Corporation