Uniden TRU3466 owner manual Choose the dialing mode, For 2 line subscriptions

note

For 2 line subscriptions,

•If the two phone lines are in one modular jack, connect using TEL LINE 1-2 jack.

•If the two phone lines are on two separate modular jacks, connect using both TEL LINE 1-2 and TEL LINE 2 jacks.

•Make sure your battery pack is fully charged before choosing the dial mode.

After installing the battery pack in the handset, charge your handset at least 15-20 hours before plugging into the phone line. Once the handset battery pack is fully charged, connect the telephone line cord to the base and telephone wall outlet.

5) Connect the telephone line cord to the TEL LINE 1-2or TEL LINE 2 jack and a telephone outlet once the handset is fully charged.

tip	If your telephone outlet isn´t
	modular, contact your telephone	Modular
	company for assistance.

D. Choose the dialing mode

Most phone systems use tone dialing which sends DTMF tones through the phone lines. However some phone systems still use pulse dialing such as in rural areas. The default setting is tone dialing. Depending on your dialing system, set the mode as follows:

1) Press and hold flash on the base until you hear a conf irmation tone.

2)To set the dial mode for pulse dialing, press #.

Or to set the dial mode for tone dialing, press * /tone. A conf irmation tone sounds to indicate the setting is complete.

•If you aren´t sure of your dialing system, make a trial call.

If the call connects, leave the setting as is; otherwise, set for pulse dialing.

•If your phone system requires pulse dialing and you need to send DTMF tones for

certain situations during a call, you may ” switch-over” to tone dialing. (Refer to ” Tone Dialing Switch-over” on page 16.)

[ 10 ] G E T T I N G S TA R T E D