Uniden XC 320 Installing the Telephone on a Desk or Tabletop, Mounting the Telephone on a Wall

Page 12

Installing the Telephone on a Desk or Tabletop

Place the Base Unit on a desk or tabletop, and plug one end of the Telephone Line Cord (supplied) into the "TELLINE"jack on the Base. Plug the other end of the cord into the telephone socket.

The unique design of your XC 320 allows you to place the Handset on the Base Unit either facedown or in an upright position. The battery pack in the Handset automatically recharges in either position.

Mounting the Telephone on a Wall

Setting the Handset Retainer for use as a wall phone.

1.Remove the Handset Retainer on the Base Unit by sliding it upward.

2.Flip the Retainer over so the tab is facing up.

3.Slide the Retainer back into the Base Unit.

12

.

Image 12

Contents Uni ~n@ Table of Contents Precautions Important Safety Instructions Page Handset About Your XCXC 320 Featu res Automatic Digital Code SecurityBase Unit Controls & Functions USE LED Charge LED Handset Controls &Functions Buttons INTCButton Installing the Telephone on a Desk or Tabletop Mounting the Telephone on a WallRead This Before Installation Connecting the AC Power If you are mounting the XC 320 elsewhereCharging the Battery Pack Ei8Using Your XC Low Battery IndicatorSetting the Handset Ringer Tone Setting the Handset Ringer VolumeSetting the Base Unit Ringer Volume Using the Flash ButtonSetting the Receiver Volume Placing a CallUsing the Redial Button Using the AutoStandby FeatureAnsweri ng a Call Storing a NumberStoring the One-Touch Dialing Numbers Dialing a Stored Number One-Touch DialingErasing a Stored Number Chain DialingUsing the 2-Way Page/Intercom Feature To use the Page/Intercom from the Base UnitPress the PAGElINTCOMbutton To use the Page/Intercom from the Handset Troubleshooting BaseUnitImportant Electrical Considerations Radio InterferenceMore Than One Cordless Telephone RangeMaintenance Care General BaseHandset Warranty Unid~n@