iPod Operations
This section describes operations when connected to an Apple iPod via the USB cable.
Notes:
•See the iPod Owner’s Manual for details regarding operation conditions.
•The unit will not operate, or may operate improperly with unsupported versions.
•For a list of compatible Apple iPod unit with the this model, please contact your Clarion dealer or www.clarion.com.
•“Made for iPod” means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
iPod and iTunes are trademarks of Apple Inc., registered in the U.S. and other countries.
Connecting an iPod
When an iPod is connected to the USB slot, “Shuffle” set on the iPod will become as follows:
•“Shuffle (Albums)” play ➜ Random play
•“Shuffle (Songs)” play ➜ All random play
The iPod has two modes, the “Play mode” and the “iPod menu mode” for selecting tracks. Switch between these modes by pressing the [BND] button (1 sec.).
Note:
•To connect iPod, please use the USB cable attached in iPod.
Select iPod mode
1. Press the [SRC] button.
Playback will begin from the last file that was played on the iPod.
Notes:
•The following operations in Play mode operate
the same as in CD mode:
∗Track selection: [x], [v]
∗Pause: [ 
]
See “CD/MP3/WMA/AAC Operations” (page 14- 16) for details.
•After a Podcast file has completed playback, the pause display, or the
Setting iPod simple mode
Use this function if you wish to operate through your iPod connected to this unit via the USB cable.
∗The factory default setting is “OFF”.
1.Press and hold the [DISP] button (1 sec.).
2.Press [x] or [v] to select
3.Press the [ 
] button.
4.Press the [w] or [z] button to select “ON” or “OFF”.
•ON: Operations can be made through your iPod.
•OFF: Operations cannot be made through your iPod.
5.Press and hold the [ 
] button (1 sec.) to
store the setting and return to the previous mode.
Notes:
•When performing iPod operations using simple control mode, make the operations slowly. If repetitive operations are performed too quickly, unforseen errors may occur.
•When performing iPod operations using simple control mode, please do not operate the iPod and the unit at the same time, otherwise there may be unexpeted event happened.
•Some iPod models do not support this function. Consult your nearest Clarion dealer or website to confirm which models do not support this function.
Other various play functions (in Play mode)
Notes:
•These functions are not supported when in the iPod menu mode.
•The Random function set on the iPod remains the same after attachment/detachment of the iPod.
•The Repeat function on the iPod will be changed when you connect/disconnect the iPod to the unit.
●Repeat play
Play back one track repeatedly.
1.Press the [RPT] button.
● Random play
Play all albums within a selected category, in random order. (Corresponds to “Shuffle (Albums)” command on iPod.)
1.Press the [RDM] button.
English
CX609 27