Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough to give good reception. However, you may wish the
1.Press the On/Off button to switch on your radio.
2.If needed, press the Band button to select the FM band.
3.Press and hold the Info button until the display shows "Mono override"
on the lower line.
4.Press and release the Tuning up or down buttons until the display shows "FM Scan Zone" then press the Select button to enter the scan zone selection menu.
5.Press the Tuning up or down buttons to switch between Local and Distant options on the lower line of the display. The Distant option will allow the radio to fi nd weaker signals when scanning.
6.Press the Select button to confi rm your selection. The radio will then
revert to the normal information display. The Local or Distant setting is stored in the radio and remains in force until changed or until a System Reset.
4,6
Note: The intial setting (out of the box, or after a System Reset) causes the radio to ignore weak (distant) signals.
If you need any further advice, please call our Technical Helpline on :-
1
2
3
4,5
020 8758 0338
18