SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
PAGE
TV
No picture, no sound. | • | The screen is for the External input | • Select the TV mode. | E45 | |
|
| mode. |
|
|
|
Poor picture | • | The 75 ohm coaxial cable is not con- | • Connect the 75 ohm coaxial cable into | E39 | |
|
| nected. |
| the jack. |
|
| • | The station may have broadcast | • | Try another channel. | E45 |
|
| difficulties |
|
|
|
Snow appears on the screen. | • | The signal is being jammed by a | • Locate the antenna, antenna wires, or | – | |
|
| vehicle boat, motorbike, train, |
| unit away from the source of jamming. |
|
|
| power cable, neon signs, vacuum |
|
|
|
|
| cleaner, hairdryer. |
|
|
|
Picture is blurry. (Ghosts) | • | The antenna is not facing in the right | • | Adjust the orientation of the antenna | – |
|
| orientation. |
| in the direction of the electric waves. |
|
| • The picture is affected by a backscat- | • Change the antenna position, height, | – | ||
|
| tering of radio waves from mountains |
| orientation. |
|
|
| or buildings. |
|
|
|
A pattern with color • | The picture is affected by jamming | • | Turn off the power of the jamming | – | |
appears. |
| from other devices, e.g. TV, radio, PC, |
| source. |
|
|
| Fax. |
|
|
|
The color fades. | • | The color or tint is not correctly | • Adjust the color, tint. | E48 | |
|
| adjusted. |
|
|
|
| • | The station may have broadcast | • | Try another channel. | E45 |
|
| difficulties |
|
|
|
The screen looks snowy. | • | The antenna is not facing the right | • | Adjust the orientation of the antenna | – |
(Snow noise) |
| orientation. |
| in the direction of the radio waves. |
|
| • | The antenna wire is either cut off or | • Connect the antenna wire correctly. | E39 | |
|
| detached. |
|
|
|
| • | The antenna is not facing the right | • | Adjust the orientation of the antenna | – |
|
| orientation. |
| in the direction of the radio waves. |
|
Remote control |
|
|
|
|
|
The remote control does not work properly.
•The batteries in the remote control are installed incorrectly.
•The batteries in the remote control are weak.
•The remote control is not pointed at the remote sensor of the main unit.
•There is an obstacle in the path of the remote control and the main unit.
•The remote control is too far from the main unit.
•Check the battery polarity (+ or
•Replace the batteries.
•Point the remote control at the remote sensor of the unit (Within 30 degrees horizontally left or right from the light reception area.)
•Remove the obstacle.
•Operate the remote control within 20 feet (6 meters).
E10
E10
E10
E10
E10
•This unit uses a micro computer. Malfunctions may occur when there are external noises or obstructing noises such as TV, radio, cellular phones, etc. If this unit doesn’t operate normally, turn off the power once, unplug the power cord from the AC outlet, then insert it in the AC outlet again after several seconds to turn the power on and operate.
•As the LCD panel is manufactured with extremely precise technology, it has an effective pixel ratio of 99.99% or greater. Although 0.01% or fewer pixels may not light or always stay lit, this is not a malfunction.
SERVICING:
Should this product require service, refer to the SANYO AUDIO/VIDEO limited warranty.
If you do not have a convenient SANYO service station nearby, contact the SANYO dealer where you purchased the unit. Be sure to give the model number and explain the problem. The dealer will advise you how to obtain service.