Roland owner manual Attaching the Card Protector, Rack-Mounting the AR-200, Installation

Installation

Rack-Mounting the AR-200

By attaching a rack mount adaptor to the AR-200 (RAD-50: sold separately) you can install it in an EIA rack. One RAD-50 can accommodate up to two AR-200 units.

1 Remove the four rubber feet from bottom of the unit.

fig.set-02

Note: Do not use these holes.

2	Attach the RAD-50 adaptor to the AR-200 using the screws
	that are supplied with the RAD-50.
	fig.set-03
	RAD-50

Attaching the Card Protector

By attaching the Card Protector (supplied) to the AR-200, you can prevent the

PC card from inadvertently being removed from the AR-200.

After confirming that the card is securely inserted in the card slot, use the provided screws to attach the Card Protector, as shown in the figure below.

fig.set-04

Card Protector

11