Microsoft manual HDD Modification DS5-OE

Page 10

DS5	User Guide

3.5” HDD Modification - DS5-OE

For the DS5 to recognise the internal drive, the HDD has to spin up and be ready before the system boots. For some hard drives, the spin up time can be quite long and some drives may not be recognised at all.

If this is the case with your drive, adjust the jumper on the DS5-OE bridge board to delay the boot time and leave more time for the drive to spin up. Refer to the following image for the modified jumper setting.

Note: Leave the jumper at its default position for 2.5” drives and CF cards. This modification is only necessary for 3.5” drives with a long spin up time. The DS5-OE supports 3.5” IDE hard drives up to 750GB.

Page 8 / Chapter 2 - Hardware Installation

Image 10

Contents Page Table of Contents Page Package Contents Optional AccessoriesSystem Requirements Front View Detailed View DS5Rear View Detailed View DS5M Remote Control 6 / Introduction Hardware Installation HDD Modification DS5-OE Drive Assembly DS5 HDD or CF cardDrive Assembly DS5M HDD11 / Hardware Installation 12 / System Setup 13 / Hardware Installation Wireless Kit Assembly DS5 Wireless Kit Assembly DS5M 16 / Hardware Installation 17 / Hardware Installation Software Configuration Network Category Misc1 Category Misc2 Category Misc3 Category Audio & Video Category Configuration File Page Configuration Structure Network SettingWHD HDD PC1 PC2 Firmware Update Page Shared Folder on WinXP Page Shared Folder on Windows Vista 34 / Playback Page Page Page Page File Copy Disk ManagementFile Erase Page Page Install the Cerberus FTP server on your computer FTP Server43 / Playback Mode USB DriveAutomated Play Modes Button File Page Page Daily Playlist Page Remote Commands Creating a Command file Create a new text file Tftp -i 192.XXX.XX.XX PUT C\reboot /rebootPage How do I upgrade the firmware? What is the current version of my firmware?Remote Control Key Functions Page Page 58 / Appendix Page About this Manual