Toshiba RD-XS35SC, RD-XS35SU owner manual Disabling the remote control for a temporary period

Setting up the remote control

5 While pressing EASY NAVI, press 2.

The remote control mode is set to “DR 2”.

EASY

NAVI

2

Select the same mode that you have set to the recorder.

	Mode setting
	Recorder	Remote control
When using with DR 1	D R 1	EASY+	1
	D R 2
mode	D R 3	NAVI
When using with DR 2	D R 1	EASY+	2
	D R 2
mode		NAVI
	D R 3
When using with DR 3	D R 1	EASY
	D R 2		3
mode		NAVI +
	D R 3

Introduction

Connections

Basic setup

Notes

•If the recorder’s mode and the remote control’s mode are different, the recorder’s mode (DR 1, DR 2 or DR 3) appears on the display of the front panel.

•When the batteries of the remote control are replaced or when the time indicator of the front panel flashes, check the remote control modes of both the recorder and the remote control, and re-program it if necessary.

Disabling the remote control for a temporary period

You can temporarily disable the reception of the remote control signals at the recorder, when the selection of DR 1, DR 2 and DR 3 is not sufficient while you are using several Toshiba HDD/DVD video recorders.

Press HDD and DVD buttons on the recorder at the same time for three seconds or more.

The recorder display shows “DR - OFF”, indicating that the remote control is disabled.

To enable the remote control, perform the same step again. (The display shows “DR-1 , DR-2 or DR-3” depending on your setting.)

Notes

•This function is not available in Standby mode.

•You cannot use this feature when the power is turned off, if you have set “Front Display” to “Off”.

51