Toshiba RD-XS35SU, RD-XS35SC owner manual Precautions, When not in use, Introduction

Page 6

Introduction

Precautions

Notes on handling

Never disconnect the power cord from a wall outlet while the recorder is not in standby mode, unless it is in an emergency. Doing so may cause malfunction. When shipping the recorder, the original shipping carton and packing materials come in handy. For maximum protection, repack the unit as it was originally packed at the factory.

Do not use volatile liquids, such as insect spray, near the recorder. Do not leave rubber or plastic products in contact with the recorder for a long time. They will leave marks on the finish.

The top and rear panels of the recorder may become warm after a long period of use. This is not a malfunction.

When not in use

For usual absence

Be sure to remove the disc from the recorder and turn off the power.

Prolonged absence

Unplug the recorder from a wall outlet.

Notes on locating

Place the recorder on a level surface. Do not use it on a shaky or unstable surface such as a wobbly table or inclined stand. The loaded disc may dislodge from its proper position and cause damage to the recorder.

Before placing the recorder, make sure that the surface can stand the weight of the recorder. Never place the recorder in a high location to avoid damage to the product or person by an accidental fall of the recorder.

When you place this recorder near a TV, radio, or VCR, the playback picture may become poor and the sound may be distorted depending on the condition and location of said equipment. In such an event, place the recorder as far away much as possible from the TV, radio, or VCR.

To avoid damage to this product, never place or store the unit in direct sunlight; hot, humid areas; or areas subject to excessive dust, oily smoke, cigarette smoke or vibration.

Notes on cleaning

Use a soft, dry cloth for cleaning.

Do not use any type of solvent, such as thinner or benzine, as they may damage the surface of the recorder.

Notes on antennas

Image and sound quality depend very much on signal reception.

Reception may be poor in weak signal areas. In this event, consult your dealer, or purchase a commercially available antenna booster. Refer to the booster’s instruction manual for installation details.

6

Image 6
Contents RD-XS35SU RD-XS35SC See service procedure This HDD/DVD video recorder employs a Laser SystemMay result in hazardous radiation exposure Location of the required label Important Safety Instructions Additional Safety Instructions Precautions When not in useIntroduction Power outage ExemptionsIntroduction Precautions WaitConnections Installation procedure Accessories Remote control Batteries AAA xAbout the hard disc drive HDD About this productSome differences Playback RestrictionsUsing different disc types for different purposes For recording / playback Disc Mark Specification RemarksChoosing a disc For playback only Disc Mark Specification Remarks DiscOn DVD-RAM discs Introduction Choosing a discDVD-RAM discs with cartridges are recommended for recording On DVD-R discs On DVD-RW discsMarks on DVD video discs On handling discs Structure of disc contentsOn cleaning discs On storing discsTable of Contents Open the cover Insert batteries AAA size Preparation of the remote controlOperating with the remote control Close the coverConnection procedure When you connect a TV equipped with audio/ video inputsWhen you connect an audio system Connecting an antenna and TV ConnectionsConnect the power cord of the recorder to a wall outlet Connect to a TV equiped with audio/video inputsConnecting to cable TV signal You will need toThis set-up will allow you to Connecting to a satellite system When the satellite system has audio/video outputsConnecting the G-LINKcable Connecting to a TV equipped with component video inputs Connecting to an audio system Make the setting onPage Basic setup Starting up the recorder Basic setupTurning the power on Startup/finishing closing iconsIf a message appears Press To select Change system Settings, then press Enter TV Guide On Screen setupPress To select Setup Press To select No, repeat setup Process, then press EnterSetup selection CountryPress / to select, then press Enter ZIP or postal code Cable serviceBasic setup TV Guide On Screen setup Cable connectionTuning channel for the cable box Cable inputCable box brand name 12Antenna connection Press / to select, then press Enter 13Confirmation14Confirmation 15InformationRead the information and press Enter Press / to select Initial settings, then press Enter Language settingPress Setup To select Language, then pressSatellite set top box setting Press Setup to display the setup menuPress Adjust or / to set DBS to Not used or Use Basic setup Satellite set top box setting Press EnterSatellite set top box brand code RCAOutput sound setting Press / to select Picture/Audio settings, then press EnterPress / to select Audio out select, then press Enter Once the proper setting is selected, press Press / to select the output sound formatTV shape setting Press / to select Display settings, then press EnterPress / to select TV shape, then press When the proper setting is selected, press Press / to select the picture shapeRelease TV Code Remote control settingsOperating your TV with the remote control Take this step according to your preference and usageBrand code table JVCSetting up the recorder Press Setup Press / to select Operational settings, then press EnterDisabling the remote control for a temporary period Your Responsibility Limited Ninety 90 Day Warranty on LaborLimited One 1 Year Warranty on Parts Rental UnitsHow to Obtain Warranty Services Page Memo Printed on 70% Recycled Paper
Related manuals
Manual 225 pages 61.34 Kb