D-Link DSM-320 manual Setup, Wireless

Setup (continued)

Configuration: Select Static or DHCP by pressing the up arrow or down arrow. When the desired option is highlighted, press ENTER on the remote. If Static is selected, you will need to input the IP, Netmask, Gateway, and DNS.

A DHCP-enabled router automatically assigns IP addresses to devices on your network. If you have a DHCP-enabled router, select DHCP.

If you do not have a DHCP -enabled router, you will select Static and provide the following information:

Entering address information:

Press ENTER on the remote control to select a highlighted field. Enter the address information by using the number keys (0-9) on the remote control. Use the dot button (“.”) on the remote control as you would when entering an address on a computer. The CLEAR button will erase the entire field. Use the left arrow to erase one character.

IP: Enter the IP address of the DSM-320.

Netmask: Enter the subnet mask of the DSM-320.

Gateway: Enter the IP address of the router on your network.

DNS: Enter the IP address of the domain name server.

Wireless

SSID: Enter the SSID (Service Set Identifier, or the name of the wireless network) by pressing ENTER on the remote control when the field is highlighted. The on-screen keyboard will appear and you can manually enter an SSID.

Site Survey: When highlighted, press ENTER on the remote control. A list of available SSID’s will appear. Navigate the list using the up and down arrows.

Mode: Ad-Hoc Mode is used for peer to peer wireless networks that do not contain a router or an access point. Infrastructure Mode is used for networks with an access point or router. To toggle between the two, press the ENTER button when Mode is highlighted. The up arrow and down arrow will toggle between the two options. Press ENTER again to select.

82