Philips MCM196D Before using the remote control, FM Antenna, Speakers Connection Front Speakers

Page 12

Preparations

English

FM Antenna

It is unnecessary to connect the FM pigtail antenna since it is fixed to the main unit.

●Adjust the FM antenna for optimal FM stereo reception.

CSpeakers Connection

Front Speakers

Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left

speaker to "LEFT", coloured (marked) wire to "+" and black (unmarked) wire to "-".

Before using the remote control

1Pull out the plastic protective sheet.

2Select the source you wish to control by pressing one of the source select keys on the remote control (for example CD,TUNER).

3Then select the desired function (for example

É, í, ë).

12

●Fully insert the stripped portion of the speaker wire into the terminal as shown.

Notes:

–For optimal sound performance, use the supplied speakers.

–Do not connect more than one speaker to any one pair of +/- speaker terminals.

–Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.

Replacing battery (lithium CR2025) into the remote control

1Push to open the battery tray.

2Replace a new battery according to the indicated polarity.

3Push the battery tray back to close it.

CAUTION!

–Remove battery if it is exhausted or will not be used for a long time.

–Batteries contain chemical substances, so they should be disposed of properly.

–Perchlorate Material-special handling may apply. See www.dtsc.ca.gov/ hazardouswaste/perchlorate.

12

Image 12

Contents Docking Entertainment System MCM196DImportante C R O S Y S T E M M C M 1 9 6 D For Customer Use Returning the enclosed cardRegistering your product guar Class II equipment symbol Disconnet device shall remain Readily operableMaterials English FrançaisIndex Contents Supplied accessories Safety InformationGeneral Information Environmental InformationHearing Safety Listen at a moderate volumeTo establish a safe volume level Set your volume control at a low settingPower PreparationsRear connections Antenna Connection AM AntennaBefore using the remote control Replacing battery lithium CR2025 into the remote controlFM Antenna Speakers Connection Front SpeakersControls on the system and remote control Controls available on the remote control onlyFirst time setup/power up To reinstall Plug and PlayBasic Functions To exit without storing the Plug and PlaySwitching the system on Adjusting volume and soundPower-saving automatic standby CD/MP3 Operation Loading a discBasic playback controls Playing an MP3/WMA discDifferent play modes Shuffle and Repeat Programming track numbersReviewing the programme Erasing the programmeTuning to radio stations Tuning to preset radio stationsRadio Reception Programming radio stationsTape Operation/Recording Tape playbackGeneral information on recording Synchro start CD recordingMaintenance Recording from the radio Listening to an external sourceClock/Timer Setting the clockSetting the timer Activating and deactivatingPlaying iPod using the dock Dock for iPodCharging iPod battery using the dock Eco power standby mode, iPod cannot be chargedSpecifications TroubleshootingNo Disc is displayed Make sure the MP3-CD was recorded within Check the speaker connections and locationButtons 2, ¡1, 2 and Volume can function only Philips Limited Warranty ONE 1 Year Meet Philips at the Internet