Philips MCM196D quick start Basic Functions, To exit without storing the Plug and Play

Page 14

Basic Functions

English	M I C R O S Y S T E M M C M 1 9 6 D
English
	IMPORTANT:

To exit without storing the Plug and Play

●PressÇon the system.

➜ If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again.

Notes:

–If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed.

–During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode.

Before you operate the system, complete the preparation procedures.

Plug and Play (for tuner installlation)

Plug and Play allows you to store all available radio stations automatically.

First time setup/power up

1When you turn on the main supply, "AUTO INSTALL - PRESS PLAY" is displayed.

2PressÉÅ on the system to start installation.

➜"PLUG AND PLAY" .... "INSTALL" is displayed, followed by "TUNER" and "AUTO".

➜PROG starts flashing.

➜The system will automatically store the radio stations with sufficient signal strength, starting from FM, then followed by AM band.

➜When all the available radio stations are stored or the memory for 40 presets are used, the last preset radio station will be played.

To reinstall Plug and Play

1In standby mode, press and holdÉÅon the system until "AUTO INSTALL - PRESS PLAY" is displayed.

2PressÉÅagain to start installation.

➜ All previously stored radio stations will be replaced.

14

Image 14

Contents Docking Entertainment System MCM196DImportante C R O S Y S T E M M C M 1 9 6 D Registering your product guar For Customer UseReturning the enclosed card Materials Class II equipment symbolDisconnet device shall remain Readily operable English FrançaisIndex Contents General Information Supplied accessoriesSafety Information Environmental InformationTo establish a safe volume level Hearing SafetyListen at a moderate volume Set your volume control at a low settingRear connections PowerPreparations Antenna Connection AM AntennaFM Antenna Before using the remote controlReplacing battery lithium CR2025 into the remote control Speakers Connection Front SpeakersControls on the system and remote control Controls available on the remote control onlyBasic Functions First time setup/power upTo reinstall Plug and Play To exit without storing the Plug and PlayPower-saving automatic standby Switching the system onAdjusting volume and sound Basic playback controls CD/MP3 OperationLoading a disc Playing an MP3/WMA discReviewing the programme Different play modes Shuffle and RepeatProgramming track numbers Erasing the programmeRadio Reception Tuning to radio stationsTuning to preset radio stations Programming radio stationsGeneral information on recording Tape Operation/RecordingTape playback Synchro start CD recordingMaintenance Recording from the radio Listening to an external sourceSetting the timer Clock/TimerSetting the clock Activating and deactivatingPlaying iPod using the dock Dock for iPodCharging iPod battery using the dock Eco power standby mode, iPod cannot be chargedNo Disc is displayed SpecificationsTroubleshooting Make sure the MP3-CD was recorded within Check the speaker connections and locationButtons 2, ¡1, 2 and Volume can function only Philips Limited Warranty ONE 1 Year Meet Philips at the Internet