Philips MCM196D quick start Specifications, Troubleshooting, No Disc is displayed

Page 24

Specifications

English

AMPLIFIER

 

Output power

2 x 4W RMS

FTC output power

3 W

Signal-to-noise ratio

60 dBA (IEC)

Frequency response

125 – 16000 Hz

Impedance loudspeakers

4

CD PLAYER

 

Frequency range

125 – 16000 Hz

Signal-to-noise ratio

65 dBA

TUNER

 

FM wave range

87.5 – 108 MHz

AM wave range

530 – 1700 kHz

Sensitivity at 75

 

– FM 26 dB sensitivity

20 µV

– AM 26 dB sensitivity

5 mV/m

Total harmonic distortion

5%

TAPE DECK

 

Frequency response

 

Normal tape (type I)

125 – 8000 Hz (8 dB)

Signal-to-noise ratio

 

Normal tape (type I)

40 dBA

Wow and flutter

0.4% JIS

SPEAKERS

Bass reflex system

Dimensions (w x h x d) . 146 x 228 x 160 (mm)

GENERAL INFORMATION

AC Power

120 V / 60 Hz

Dimensions (w x h x d) ...

146 x 228 x 216(mm)

Weight (with/without speakers)

...............................................................

approx. 4.4 / 2.0 kg

Power consumption

 

Active

30 W

Standby

< 4 W

Eco Power Standby

< 1 W

Specifications and external appearance are subject to change without notice.

Troubleshooting

WARNING

Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help.

Problem

NO DISC” is displayed.

Solution

Insert a disc.

Check if the disc is inserted upside down.

Wait until the moisture condensation at the lens has cleared.

Replace or clean the disc, see “Maintenance”.

Use a finalized CD-RW or a correct MP3-CD format disc.

24

Image 24
Contents Docking Entertainment System MCM196DImportante C R O S Y S T E M M C M 1 9 6 D For Customer Use Returning the enclosed cardRegistering your product guar Class II equipment symbol Disconnet device shall remain Readily operableMaterials English FrançaisIndex Contents Supplied accessories Safety InformationGeneral Information Environmental InformationHearing Safety Listen at a moderate volumeTo establish a safe volume level Set your volume control at a low settingPower PreparationsRear connections Antenna Connection AM AntennaBefore using the remote control Replacing battery lithium CR2025 into the remote controlFM Antenna Speakers Connection Front SpeakersControls on the system and remote control Controls available on the remote control onlyFirst time setup/power up To reinstall Plug and PlayBasic Functions To exit without storing the Plug and PlaySwitching the system on Adjusting volume and soundPower-saving automatic standby CD/MP3 Operation Loading a discBasic playback controls Playing an MP3/WMA discDifferent play modes Shuffle and Repeat Programming track numbersReviewing the programme Erasing the programmeTuning to radio stations Tuning to preset radio stationsRadio Reception Programming radio stationsTape Operation/Recording Tape playbackGeneral information on recording Synchro start CD recordingMaintenance Recording from the radio Listening to an external sourceClock/Timer Setting the clockSetting the timer Activating and deactivatingPlaying iPod using the dock Dock for iPodCharging iPod battery using the dock Eco power standby mode, iPod cannot be chargedSpecifications TroubleshootingNo Disc is displayed Make sure the MP3-CD was recorded within Check the speaker connections and locationButtons 2, ¡1, 2 and Volume can function only Philips Limited Warranty ONE 1 Year Meet Philips at the Internet