Philips MCM196D quick start Make sure the MP3-CD was recorded within

Page 25

Troubleshooting

Radio reception is poor.

Recording or playback cannot be made.

The tape deck door cannot open.

The system does not react when buttons are pressed.

Sound cannot be heard or is of poor quality.

The left and right sound outputs are reversed.

The remote control does not function properly.

The time is not working.

If the signal is too weak, adjust the antenna or connect an external antenna for better reception.

Increase the distance between the Mini HiFi System and your TV or VCR.

Clean deck parts, see “Maintenance”.

Use only NORMAL (IEC I) tape.

Apply a piece of adhesive tape over the missing tab space.

Remove and reconnect the AC power plug and switch on the system again.

Remove and reconnect the AC power plug and switch on the system again.

Adjust the volume.

Disconnect the headphones.

Check that the speakers are connec ted correctly.

Check if the stripped speaker wire is clamped.

Make sure the MP3-CD was recorded within

32-256 kbps bit rate with sampling frequencies at 48 kHz, 44.1 kHz or 32 kHz.

Check the speaker connections and location.

Select the source (CD or TUNER, for example) before pressing the function button (É,í,ë).

Reduce the distance between the remote control and the system.

Insert the batteries with their polarities (+/– signs) aligned as indicated.

Replace the batteries.

Point the remote control directly towards the IR sensor.

Set the clock correctly.

Press and hold Timer on/off to switch on the timer.

If recording or tape dubbing is in progress, stop recording.

Power has been interrupted or the power cord has been disconnected. Reset the clock/timer.

English

25

Image 25
Contents MCM196D Docking Entertainment SystemImportante C R O S Y S T E M M C M 1 9 6 D Returning the enclosed card For Customer UseRegistering your product guar Disconnet device shall remain Readily operable Class II equipment symbolMaterials Français EnglishIndex Contents Safety Information Supplied accessoriesGeneral Information Environmental InformationListen at a moderate volume Hearing SafetyTo establish a safe volume level Set your volume control at a low settingPreparations PowerRear connections Antenna Connection AM AntennaReplacing battery lithium CR2025 into the remote control Before using the remote controlFM Antenna Speakers Connection Front SpeakersControls available on the remote control only Controls on the system and remote controlTo reinstall Plug and Play First time setup/power upBasic Functions To exit without storing the Plug and PlayAdjusting volume and sound Switching the system onPower-saving automatic standby Loading a disc CD/MP3 OperationBasic playback controls Playing an MP3/WMA discProgramming track numbers Different play modes Shuffle and RepeatReviewing the programme Erasing the programmeTuning to preset radio stations Tuning to radio stationsRadio Reception Programming radio stationsTape playback Tape Operation/RecordingGeneral information on recording Synchro start CD recordingRecording from the radio Listening to an external source MaintenanceSetting the clock Clock/TimerSetting the timer Activating and deactivatingDock for iPod Playing iPod using the dockEco power standby mode, iPod cannot be charged Charging iPod battery using the dockTroubleshooting SpecificationsNo Disc is displayed Check the speaker connections and location Make sure the MP3-CD was recorded withinButtons 2, ¡1, 2 and Volume can function only Philips Limited Warranty ONE 1 Year Meet Philips at the Internet