Heat Controller REG-123A, REG-71A service manual Slide the unit into the cabinet.See Fig

Installation

10. Slide the unit into the cabinet.(See Fig. 8)

CAUTION: For security purpose, reinstall screws (Type A) at the cabinet's sides.

	Power cord
Screw(Type A)
Screw(Type A)	Figure 8

11.Cut the Foam-Strip to the proper length and insert between the upper and lower window sash.

(See Fig. 9)

Foam-Strip 8

Figure 9

12.Attach the window Locking Bracket with a type C screw. (See Fig. 10)

13

Figure 10

13.Attach the front grille to the cabinet by inserting the tabs on the grille into the tabs on the front of the cab- inet. Push the grille in until it snaps into place.

(See Fig. 11)

14.Lift the inlet grille and secure it with a type A screw through the front grille.(See Fig. 12)

Figure 11 Figure 12

Figure 13

Service Manual 13