Tip
•Press the J key to cancel the operation without saving and return to the stop mode.
10.2Replacing batteries or rechargeable power packs
Caution
•Do not remove batteries or rechargeable batteries from the device while it is recording. If you do this, data may be damaged or lost. Device malfunctions may also occur.
When the batteries are nearly empty, the battery indicator blinks; you should replace them. The number of the rechargeable power pack charge cycles is also limited. If the rechargeable batteries do not provide any power after a complete charging cycle via the computer, they must be replaced.
Proceed as described in 4.1 Inserting the batteries.
Note
•If it takes longer than 2 minutes to replace the batteries, you may have to reset the time.
•Never try to recharge alkaline or
•Batteries and rechargeable batteries contain substances that may pollute the environment. Used batteries and rechargeable batteries should be disposed of at an official collection point.
10.3Replacing the remote control battery (DVT5500, DVT7000)
Note
•Follow the instructions on handling the device, especially the batteries shown in 1 Important safety information. Only use CR2025 type batteries for the remote control.
1Remove the battery cover from the remote control by opening the latch of the battery compartment on the back of the remote control and take out the battery compartment.
54 Service | Table of contents |