Krell Industries iPod Docking Station manual Connect the Papa Dock to Your System, 20 12 VDC Out

Page 8

Connecting the Papa Dock to Your System AC Power Guidelines for the Papa Dock Papa Dock Back Panel Connections

CONNECTING TO YOUR SYSTEM, continued

Connect the Papa Dock to Your System

With the KID docked onto the Papa Dock:

1. Connect the loudspeaker cables to the Papa Dock amplifier channel output binding posts (16) located on the back panel.

The binding post terminals accept spade lugs, bare wire, or pins. Use the red terminal for the positive connection and the black terminal for the negative connection.

IMPORTANT: Tighten loudspeaker binding posts by hand only.

5.Plug the AC power cord into the amplifier’s IEC connector (21).

6.Plug the other end of the AC power cord into the AC wall outlet.

The amplifier is now ready for operation.

AC Power Guidelines for the Papa Dock. Krell

recommends operating the Papa Dock amplifier

from a dedicated 15-amp AC power line. Please

contact your Krell dealer, distributor, or Krell

before using any devices designed to alter or sta-

bilize the AC power for the Papa Dock.

FIGURE 7 Papa Dock Back Panel Connections

RIGHT OUTPUT

 

 

 

 

 

 

 

 

 

 

 

 

 

FTLE OUTPUT

 

 

 

 

 

 

 

 

 

 

 

 

 

PAPA DOCK

KRELL INDUSTRIES,. INC

45 CONNAIR ROAD

NGE,ORAC T 06477-3650

USA

IDEOV OUT

OMPOSITEC -VIS DEO

RS-232 IN

NO USER SERVICEABLE PARTS INSIDE

16

17

18

19

AMPLIFIER CHANNEL OUTPUTS

16Left and Right Outputs

Two channel outputs via 5-way binding posts.

VIDEO OUTPUTS

17Composite Video Output

One composite video output with an RCA connector.

18S-Video Output

One S-Video output with a DIN connector.

REMOTE CONNECTIONS

19Comm Port RS-232 Connector

Sends software updates directly to the KID using an external computer control system.

50/60 Hz

DC 12V

UTO

30mA MAX.

ADEM IN USA

20

16

21

2012 VDC Out

Sends a 12 V power on/off signal via a 12 V trigger cable to other Krell components and to other devices that incorporate 12 V power on/off trigger input.

When the Papa Dock is in the operational mode and a trigger is enabled, the 12 VDC Out provides 12 V of DC output. When the Papa Dock is in the stand-by mode or off, or if a trigger is not enabled, the DC out- put is 0 V.

POWER CONNECTION

21IEC Connector

A standard male IEC power connector, for use with the AC power cord.

8 Krell / Papa Dock

Image 8
Contents Owner’s Reference Krell / Papa Dock Owner’s Reference, vIntroduction Overview1UNPACK the KID Unpack the Papa DockComponent Ventilation Install the Battery KID RemotePositioning the components in the listening area Placement Considerations KID / Papa Dock ConnectionPapa Dock requires ventilation clearance To connect the KID to the Papa DockConnect the KID to Your System AC Power Guidelines for the KID. Use onlyConnect to Your System AC Power Guidelines for the Papa Dock. Krell Comm Port RS-232 ConnectorConnect the Papa Dock to Your System Left and Right OutputsInserting the iPod-device Into Dock Connector OperationTOP only Front Panel onlyFront Panel and Remote Remote onlyTOP and Front Panel only KID Specifications Papa Dock Specifications