SUPER MICRO Computer 6015B-3, 6015B-T user manual JLAN1/2 Ethernet Ports, Alarm Reset JAR

SUPERSERVER 6015B-3/6015B-T User's Manual

JLAN1/2 (Ethernet Ports)

Two Ethernet ports (designated JLAN1 and JLAN2) are located beside the VGA port on the I/O backplane. These ports accept RJ45 type cables.

Alarm Reset (JAR)

The system will notify you in the event of a power supply failure. This feature assumes that Supermicro redundant power supply units are installed in the chassis. Connect a microswitch to the JAR header to disable the power supply fail alarm. Note: this header is unused with the 6015B-3/6015B-T.

Alarm Reset

Pin Definitions (JAR)

Pin# Definition

2 +5V

1 Ground

Compact Flash Card PWR Connector

ACompact Flash Card Power Connector is located at JWF1. For the Compact Flash Card to work properly, you will first need to connect a power cable to JWF1 and correctly set the Compact Flash Jumper (JCF1).

SGPIO

The two headers labeled SGPIO1 and SGPIO2 are for SGPIO (Serial Gen- eral Purpose Input/Output). SGPIO provides a bus between the SAS/SATA controller and the SAS/SATA drive backplane to provide SAS/SATA en- closure management functions. Con- nect the appropriate cables from the backplane to the SGPIO1 and SGPIO2 headers to utilize SAS/SATA manage- ment functions on your system.

SGPIO Header

Pin Definitions (SGPIO1, SGPIO2)

Pin#	Definition	Pin #	Definition
1	NC		NC
		2
3	Ground		Data
		4
5	Load		Ground
		6
7	NC		NC
		8

Note: NC indicates no connection.

5-18