SUPER MICRO Computer Serverboard Features, Processors, Memory, Onboard SAS 6015B-3, Serial ATA

SUPERSERVER 6015B-3/6015B-T User's Manual

SuperServer 6015B-3/6015B-T User's Manual

Note: the "V" and "B" at the end of a server name (e.g. 6015B-3V or 6015B-3B) denotes the chassis color. V is for silver and B is for black.

1-2 Serverboard Features

At the heart of the SuperServer 6015B-3/6015B-T lies the X7DBR-3/X7DBR-E, a dual processor serverboard based on Intel's 5000P chipset. Below are the main features of the X7DBR-3/X7DBR-E (see Figure 1-1 for a block diagram of the chipset).

Processors

The X7DBR-3/X7DBR-E supports single or dual 771-pin Intel Xeon 5400/5300/5200/5100/5000 series processors at a FSB speed of 1333/1066/667 MHz. Please refer to the serverboard description pages on our web site for a complete listing of supported processors.

Memory

The X7DBR-3/X7DBR-E has eight 240-pin DIMM sockets that can support up to

32GB of ECC FBD (Fully Buffered DIMM) DDR2-667 or DDR2-533 SDRAM. The memory is an interleaved configuration, which requires modules of the same size and speed to be installed in pairs. Please refer to Chapter 5 for memory speed jumper settings.

Onboard SAS (6015B-3)

An onboard Adaptec AIC-9410 Serial Attached SCSI (SAS) controller in integrated into the X7DBR-3, which supports eight SAS hard drives with SES2. The SAS drives are connected to a backplane that provides power, bus termination and configura- tion settings and are hot-swappable units. Note: The operating system you use must have RAID support to enable the hot-swap capability and RAID function of the SAS drives. RAID 0, 1, 5 and 10 are supported.

Serial ATA

An on-chip (ESB2) SATA controller is integrated into the X7DBR-E to provide a six-port, 3 Gb/sec Serial ATA subsystem, which is RAID 0, 1 and 10 supported. The SATA drives are hot-swappable units. Note: The operating system you use

1-2