KID / Papa Dock Connection | Krell Industries iPod Docking Station

Placement Considerations, continued The KID / Papa Dock Connection

PLACEMENT CONSIDERATIONS, continued

Component Ventilation, continued

If the KID is placed in a closed cabinet, more than eight inches (20 cm) of clearance may need to be provided above and below the component, or small fans may be needed to increase ventilation.

The air space between the chassis and shelf must be unobstructed.

The Papa Dock requires ventilation clearance:

—at least two inches (5 cm) above, below, and on each side.

THE KID / PAPA DOCK CONNECTION

5 To connect the KID to the Papa Dock:

1.Remove the connector plate from the bottom of the KID, using the T-10 Torx wrench provided in the Papa Dock accessory box.

2.Place the KID and the Papa Dock side-by- side, with the front panel facing toward you.

3.Lift the KID up and position it over the con- nection well (6) in the Papa Dock.

4.Lower the KID gently but firmly onto the Papa Dock docking connector (7).

FIGURE 2 Connecting the KID to the Papa Dock

To disconnect the KID from the Papa Dock:

1.Facing the front of the two components, insert your fingers in the plunger holes on the bottom panel of the Papa Dock.

2.Push up both plungers (8) simultaneously. The plungers elevate the KID, disconnecting it from the Papa Dock.

3.Lift the KID out of the connection well on the Papa Dock, and set the KID aside.

POWER	BASS	TREBLE	VOLUME	AUX
				INPUT

POWER

6 Krell / Papa Dock