■Listening to radio
Number buttons 
| SET |
|
|
4 | ¢ |
| TUNER BAND |
| TUNER BAND | PRESET TUNING | |
|
| ||
| FM MODE |
|
|
|
| 4 | ¢ |
You can listen to FM and AM (MW/LW) stations. Stations can be tuned in manually, automatically, or from preset memory storage.
■Before listening to the radio, fully extend the FM telescopic antenna.
Tuning in to a station
■1. Press TUNER BAND.
The band and frequency you were last tuned into appear on the display.
Each time you press the button, the band changes as follows: FM = AM = (back to the beginning)
■2. Select a station using one of the following methods.
•When you tune into an FM stereo broadcast, the STEREO indicator lights up and you can hear stereo effect.
If an FM stereo broadcast is hard to receive or noisy, press FM MODE on the remote control. The MONO indicator lights up and the sound becomes monaural, but the reception improves. When you tune in to another station, the MONO indicator goes off and stereo effect restores automatically.
Note: AM broadcasts are monaural.
■Manual Tuning
Press 4 or ¢ repeatedly to move from frequency to frequency until you find the station you want.
OR
■Auto Tuning
Press and hold 4 or ¢ for one second or more.
The frequency changes automatically until a station frequency is found.
OR
■Preset Tuning (possible only after presetting stations)
Select the desired preset number (displayed as
(After one second)
PRESET TUNING button: Each time you press the button, the preset number increases.
Number buttons: | To select |
| To select |
| To select |
| press 10. |
Notice: To adjust the reception condition
For FM: Adjust the FM telescopic antenna’s length, angle and direction until the best reception is obtained.
For AM: Change the direction of the system to obtain the best reception.
Placing the system near the window, for example, will improve AM reception.
9